Hydraulic Line Replacement

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 5, 2018
Threads
74
Messages
2,424
Location
Santa Fe, New Mexico
I'm thinking about swapping all of the hard and soft lines on my FJ40. I really don't want to mix rusty components with new ones, how do professionals do it? I have a '75 FJ40 with average deterioration, and essentially unknown history. The system bleeds clean fluid, aside from the clutch bleeder. The brake master needs replacement, and, I definitely need to replace a front wheel cylinder, and the rear soft line/hose is too short. Any advice on tools or techniques?
 
Get a high quality flare nut wrench for brake line fittings. It is pretty much straight forward swapping parts. Start at one end and do each piece one at a time.
 
I've had trouble with flare nuts before. My trick was to piggy back the 10mm flare nut wrench with a vice grip on the outside crescent. It keeps the internal hex from opening up and rounding the nut.
 
Brake line require a double flare on the ends of the lines. So, you need a double flare tool, tubing cutter, tubing bender, and typically you can buy line in bulk and bend and cut it to match the old lines. You can get steel line or Ni-cop which won't rust. I like to use Ni-cop on the frame lines and steel on the lines that go on the axle. Ni-cop is relatively easy to work with, and is softer than steel. Or, you can contact rainman , who's a member on this site. He makes replacement lines like the stk ones. Some vendors on this site sell OEM stk replacement rubber lines. You can find a bunch of videos on the web on double flaring brake lines.
 
You can also buy complete sets ready to go from places like cruiser corps or classic tube. I bought a set of stainless lines from Classic Tube several years ago but don't see it as an option anymore, cruiser corps has stainless listed.
 
I used heat (MAP) to heat up the nuts on the lines but BEWARE...... sometimes they BLOW UP. I thought the line being open on one end would be enough to vent the line. If its really clogged, it doesn't matter and will POP.

hOOter
 
Back
Top Bottom