How do I deal with this?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 14, 2006
Threads
89
Messages
868
Location
Woody P
Hi all,

I can't figure out a way to get the fan belt off without cutting out this shield. There is just no room between the water pump pully to slip it through. The second pic shows the bottom side of the shield from front to back. I am assuming this is a PO mod. Thanks Jon
fan belt 003 (3).webp
fan belt 001 (2).webp
 
Loose the shield.....
 
Factory thats the way Toyota made it ! but ...it looks like a 2F with a 1F mud shield you may have to un- bolt the radiator support lift up the radiator just enough and slide the shield forward to free the belt slip around the fan takes a little patience but..its ben done i'v learned :o the hard way...Dusty
 
A simpler, much easier alternative is to loosen the front engine mount fasteners, undo them out almost all the way, and jack up the front of the motor just enough to slip off the old belt and slip in the new one. You'll be glad you didn't chop up the splash pan.
 
On mine I have to twist the belt vertical to be able to slip it in between the shield and pulley, so that the teeth are flat against the pulley. It's a really tight fit though, if you don't twist it and keep it vertical while pulling, it will get jammed in between. I usually need to stand on my bumper with my head in the engine compartment, with one hand on each side of the pulley to be able to twist both side of the belt. Gets a lot easier with practice, i was ready to just cut the belt off the first time, now I can do it almost without thinking about it.
 
A simpler, much easier alternative is to loosen the front engine mount fasteners, undo them out almost all the way, and jack up the front of the motor just enough to slip off the old belt and slip in the new one. You'll be glad you didn't chop up the splash pan.

Sounds easy in theory, but I don't think I will try this one just yet. I would have to lift the engine almost 3 inches to clear the belt.
 
Factory thats the way Toyota made it ! but ...it looks like a 2F with a 1F mud shield you may have to un- bolt the radiator support lift up the radiator just enough and slide the shield forward to free the belt slip around the fan takes a little patience but..its ben done i'v learned :o the hard way...Dusty

This I will give a shot, Thanks for all the responses fellas.
 
Grease the shield, use one of those credit cards you get in the mail or a piece of plastic/poly and wedge the belt down and crank engine (Pull coil wire) I bet the shield would give and it would slip past. Reverse to install...
 
I actually modified the splash shield on my '76. I drilled new front mounting holes and welded on additional sheet metal with mounting holes for the mounting bolts on the sides. Then I moved it about 1" forward, giving me lots of clearance between the crank pulley and the shield. It's not hard to do and it sure makes changing belts easy.
 
Back
Top Bottom