hose replacement

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 8, 2016
Threads
16
Messages
55
Location
Lake Jackson, TX
So, it came to my attention that I need to replace pretty much every rubber hose in the engine bay of my cruiser. I crawled under her today, and touched a few hoses... The free standing part (not clamped down) was basically the consistency of peanut butter. REALLY deteriorated.
So, where can I get a complete package of all the hoses I need?
I don't really even know what all the hoses do, but I learn fast. I wish someone could just point each one out and tell me once what they do. Then I would know.
 
Following
 
Here I have attached two pictures of the worst hoses on the vehicle. They are just to the right and front of the oil pan.

20160327_163756.webp


20160327_163817.webp
 
Talk to one of the many parts suppliers on this forum. @beno @cruiserdan etc
I wish someone could just point each one out and tell me once what they do. Then I would know.
All that information is in the FSM.
 
Is there a concise diagram in the FSM of ALL the hoses?
If so, can someone please scan those pages and send them to me. Or give me a link. Or something.
I am on about as tight of a budget as you can imagine, and so $200 for the FSM is a no go. I know I need it. I know that. I know I will get one, someday. I know that it is more valuable that most tools. But right now, my budget just can't find those extra funds. I am on a: "I need to keep this running" budget. not a "I need this because it makes life so much easier budget"
 
What year is it
 
I did, but I can't seem to find the year that I have. I have a 1992. Am I blind? (quite possibly)
 
I only have the 96 fsm and a 97 lx engine manual. I just searched the forum for fsm and found one but I had to dig through the posts
 
Those look like your trans cooler lines to me. I went to NAPA and just bought like 8ft of trans hose. Its .5mm smaller than toyota so took some pushing to get them on. Take your old one off, measure the new one to same length and cut. Or contact the parts dealers here if you want oem.
 
Back
Top Bottom