Hood buffeting?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 3, 2006
Threads
259
Messages
1,935
Location
Fort Apache: Victoria
Anyone have a hood that kind of buffets at highway speed?


My hood has a couple of small dents from the PO. Not very deep, but you can see them if you look. I wonder if they have compromised the integrity of the steel to the point it buffets.
 
Mine willbuckle in the middle and otherwise shimmy a bunch at anythong above 65-70. I think I remember the problem is the sheet metal has separated from the cross supports.....and someone used expanding foam to re-adhere and stiffen....wonder how long that will last????
 
I just blew some great stuff into mine today...funny timing. :)

You're always spraying some sort of polymer somewhere... :D

What did you use? I imagine the underhood temps are going to be brutal for most foams and coatings
 
My T100 does this badly, the PO's solution was small pieces of rigid insulation--tougher than the spray stuff and heat resistant.
 
LOL

I've noticed this on both my '97 LX and '97 LC...Just figured it was normal and a cruiser thing :confused:

Maybe its not...You can see the hood buffet and if you look at the gap between the hood and air intake vent by the windshield on mine you can see the hood moving. Not much, but it moves.
 
no movement here, also look at the rubber bumpers, if they are not adjusted properly the hood can move arround
 
Mine does the same thing. I bet if you take off your insulation you will find that the factory sealant, silicone whatever that stuff is called, that bonds the outer skin of the hood to the stiffeners has separated. That is what has happened to mine. A local body shop said they make a special product made just for this. I have not inquired what the product is, but I'm sure a local body shop supply store can give you some advice.
 
Another 80 caught on drive cam...

no movement here,

^ x2 same here no movement at all even with the speed reach above 70 or 110mph.
Salute_01.webp
 
Great Stuff disintegrated and fell out under my hood. I then used silicon. It has held in only one spot. It now looks like I have a large dent in my hood. I've got to try something else.
 
A quick question for those of you who fixed your hood, did you insualtion fall apart when you were taking it off, mines looking rough, and the clips are just breaking.
 
Back
Top Bottom