Home grown Sliders & Rear Bumper

[Broski]

Main tube 2"x4" .120 wall, kicker tube 13/4" dome .120 wall.
Still holding strong !!
Never did any cat protection. super impressed the beating they can take

 

[EricT4R]

Main tube 2"x4" .120 wall, kicker tube 13/4" dome .120 wall.
Still holding strong !!
Never did any cat protection. super impressed the beating they can take

Thanks man, I wouldn't have thought the .120 wall rectangle would have held up that well to denting!

 

[Broski]

Thanks man, I wouldn't have thought the .120 wall rectangle would have held up that well to denting!

There are some dents after nearly 10 years of hard rock crawling
But nothing major.

 

[COS80]

How did you bend the pipe?

 

[Broski]

How did you bend the pipe?

You run water or gas through pipe
I use a tubing bender to bend the tubing

This is my JD squared air over hydraulic tubing bender.

A little more trivia, pipe is measured on the inside tubing is measured on the outside therefore fitting the die of the bender correctly.