High beam light issue - <solved>

[Rogerr]

Hi gang,

My normal head lights are working ok.
my high beam works when pushing the handle to the back, but no blue light indicator
my flash high beam is NOT working
Where to start looking?

Got the switch out
saw good how it functions
cleaned the connectors, no improvement

found out that 1 wire (RY) had no power
behind the gauge console was a lose connector
no sign of the other connector

update 1
the b/w wire from the high beam handle is not connected
I found some more lose ends
its a mess

I'm starting to think its all connecting:
Blue high beam not working
Flash high beam not working

When head lights on, the fixed high beam is working, but no blue light indicator gauge console

update 2
Found the red wire in the harnass cut off

Now how to make the connection between the red wire and the HF part, what is the color of this wire in the dimmer switch?

Update 2 SOLVED

The PO made some sh*t with the wiring
but now I solved it

When dim light is on, the Flash and continue High Beam was working
The Flash not, and the High beam indicator not
When I put power on the High beam Indicator light it was working
When I connected it to RY it was not working any more

1. The 1997 is the correct wiring overview to find the solution for the flash high beam working
2. I connected the BW mass wire to the continues power wire red: Flash is now working when Dim Light is of
3. On my dashboard I cut the RY wire and put power from the flash RY wire to the dashboard and grounded it with a separate BW wire on the dashboard, see picture dashboard

 

[Pighead]

I might start by looking at the high-beam switch. I had to fiddle with mine recently, very simple on my '74

 

[Rogerr]

thx indeed
yes I was seeing this and also the handle wire diagram
I did 'shake' the wire harnas coming out the handle
I let the handle 'plop' to make sure that there is good contact

If I put on high beam the headlight goes out on both ways

Maybe with some cleaning fluid or fine sand paper?

 

[Pighead]

I used an emery board, some contact cleaner and finished with some leftover lightbulb grease. I also lightly re-arched the springy bits.

 

[pb4ugo]

You should mark and pull the wheel and clean the switch, or cycle the handle a bunch in hopes to clean the contacts. The bulb in the cluster might be bad. Be sure to disconnect the battery if you remove the cluster. There is no flash function that I'm aware of.

 

[Rogerr]

You should mark and pull the wheel and clean the switch, or cycle the handle a bunch in hopes to clean the contacts. The bulb in the cluster might be bad. Be sure to disconnect the battery if you remove the cluster. There is no flash function that I'm aware of.
View attachment 4108671View attachment 4108672

nice job

yeah, flasher high beam is not working, and main head lights go out when flashing high beam
Contacts handle are fine
So power on fixed High beam is there, but no power for flash high beam

 

[Rogerr]

nice job

yeah, flasher high beam is not working, and main head lights go out when flashing high beam
Contacts handle are fine
So power on fixed High beam is there, but no power for flash high beam

Found the red wire in the harnass cut off

Now how to make the connection between the red wire and the HF part, what is the color of this wire in the dimmer switch?

 

[Michael Hanson]

Lately every problem I’ve had with the 40,60,62,80:has been the wiring itself