HF2A output shaft upgrades?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 4, 2016
Threads
24
Messages
210
Location
Southern Oregon
I'm wondering if there are any kits to upgrade the output shaft on the transfer case. I just got a 91 with a V8 and it came with a broken rear split yoke. Want to make it stronger for the future.
 
What actually broke? The output shafts on the HF2A (V) are really stout and are behind many high HP and high torque engines. Post up a pic of the failure.
 
I'll take a pic. But, for now, to be more specific, it's not the output shaft, it's the part of the driveshaft that connects to the u-joint at the t/c. One of the ears on the yoke bent out of shape, I think it's the tube yoke....Perhaps I can have a custom driveshaft made that has stronger yokes , but with the LC flanges on the ends?
 
Not a common failure for Land Cruisers, but it does happen occasionally. Usually it is due to bearing/cap failure inside the yoke. If your current cap and bearings look good, then it may of been weakened by a previous cross that was replaced previously. John
 
do you think a SBC 383, with fuel injection(TPI) is too much torque?
 
Unmm..... No such thing I've heard :)


It sounds like s driveshaft yoke failure. As mentioned it may have been behind on maintenance or it could have been fatigued by power but have a new driveshaft made up and inform the builder of what powering will see

Lots of 383 cruisers and other power monsters out here without the issue. I'd a 4bt isn't gonna break it I doubt the small block would. Just have an upgraded yoke made and don't look back
 
okay, that's the advice I needed, thanks.
 
do you think a SBC 383, with fuel injection(TPI) is too much torque?
Toyota drive shafts are notably strong and usually require no upgrades. I've seen a few chrome axle shafts snap in crawlers with very low gearing and large rubber and even the mini truck drive shafts stand up in those conditions as a norm and LC drive shafts are even more stout.
Just for reference: The bearing cap diameter on an 80 series (at least 1993 and up) is 1/10th of an inch larger than a spicer 1350 and 1410 which iare considered 1 ton and commonly used on custom rock crawler builds.
I agree that your yoke was probably damaged due to lack of maintenance which cause a previous U-joint failure.
 
Back
Top Bottom