Help with Bestop soft top install

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 10, 2018
Threads
3
Messages
15
Location
Chino Hills, Ca
I’m having trouble installing a Bestop soft top on my 1974 Fj40. The windshield retainer slot appears to be way to narrow for the edge of the soft top. Any ideas? I know the instructions this step would be easier with two people, that’s not the issue. The edge of the soft top is just to thick for the retainer slot. Any ideas would be greatly appreciated.
1920469
 
I didn't have the Bestop but encountered a similar issue. Then I realized the plastic piece sewn to the fabric was the only part that was supposed to go in the channel. I wanted the fabric to fit in there. Does the Bestop have a piece of plastic sewn across the front of it?
 
I believe there were two different channels. One for the "bead" and one for the plastic strip. Might check with SOR.com
 
Is this a new BestTop? The Tiger Top I installed back in 96 had the flat plastic strip just like the Super Top I'm running now. IIRC correctly the old Kayline top used the round type retainer.
 
The older tops definitely used a C shaped channel that the canvas/welt HAD to be slid in one end, as opposed to the newer ‘tuck in’ design.

I never had a ‘slide in’ bikini top give me an issue. But I can think of at least 3 windstorms that pulled the welt out of a slide in channel.

Easier is not always better.
 
Semi-related question way later. I've got the Bestop windshield retainer, but it sticks out about 1/4" on each side when I have it centered. The instructions with it say that it's the right one. Did yours go on with some overlap, or did it match the width and curve of the windshield frame pretty well? Thanks
 
Back
Top Bottom