Help with alternator!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

...

IMG_20180430_181557819.webp
 
That sleeve on the upper bracket
Is it because the sleeve in the new alternator is slid out too far? The sleve is designed to be tapped in to make it "tight" when it's installed. Sometimes the sleeve ends up in the wrong place.

Lay the new one on top of your old one and compare that part of the bracket. Then tap the sleeve in or out to match.
 
It's the sleeve in the forward ear of the bracket, needs to be pushed forward, we do it with socket and c-clamp.
 
I got it in. The years of gunk buildup practically welding the sleeve in there... Sprayed some pb blaster on it and it freed up with ease... Thanks to all who helped.

I love that stuff
 


apply a drop of synthetic engine oil to each of the 4 contact surfaces , 2 ends of alternator, pivit both insides of bracket . rub all 4 contact faces

then as U push up on the alternator , wiggle it back and forth , it should POP in the bracket

Your fighting age & time bracket corrosion , so wire brush both mating faces off before applying 1 drop of oil to each

see if this works , I have used this technique on several New & rebuild DENSO alternators , due to the tight machine clearances they have
 
Back
Top Bottom