HELP! High Idle After Driving For A While

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 8, 2011
Threads
40
Messages
235
Location
Birmingham, AL
I searched but can't run this down. It's driving me crazy.

When my Cruiser starts, it idles fine. Normal high, settles down momentarily. However, after anything over a short trip, i.e., longer than a run to the grocery store about a half mile from my house, the idle jumps up to about 1800-2000. Tonight, taking my daughter to eat at the local Chik-Fil-A about six miles from my house, it was about 2300 when I put it in neutral after parking. This is extremely annyoing! :mad:

I'm almost convinced it has more to do with the speed that I've traveled to my destination rather than the length of the trip. And perhaps that magic speed is around 30 mph. But, that's just my current train of thought.

I do have a CEL... 0401. So, I know my EGR has issues. Is this related to the EGR problem? I'm thinking I'll bypass the EGR and see if that helps my issue as a start.

I've searched around for any previous experience with this issue but didn't find the right thread. Any help or advice would be greatly appreciated.
 
When it's doing that, put your foot under the gas pedal and pull toward you, it sounds like a sticking throttle cable
 
If that's all it is, I'm going to feel like a big bonehead.

I've recently cleaned the throttle body and adjusted the cable to try and alleviate the problem, thinking that gunk in the system somewhere could be responsible. It was doing it prior to cleaning, and it still does it.

I'll try pulling out on the pedal tomorrow, as it didn't occur to me to try that tactic.
 
Almost guaranteed to be a sticking throttle cable.

Be aware though that due to the way the linkage is set up, pulling up on the pedal is not as conclusive as popping the hood and manually closing the throttle.
 
Last edited:
Well, I think y'all are correct. Seems that it's the throttle cable sticking. Drove it tonight and pulled into the driveway with it idling about 1800 in neutral. A pull on the accelerator made it back off some, but playing with the throttle under the hood brought it down to 800 or so.

Any idea how much a replacement cable costs? I'm guessing that's a quick job... I will consult my FSM to be sure that I don't have to drop the tranny pan, but I also don't see why I would need to do that.
 
Oh good. Yes, hopefully that is not my problem.

Alternatively to buying a new throttle cable, I guess I could clean the existing cable? Any ideas?
 
IIRC my throttle cable was about $120 from a MUD vendor here. Hit up one of them for a new one. I wouldnt mess with cleaning it. Mine did this too when the motor got hot. Pedal got really stiff too. A new cable solved all this.
 
I searched this, am having what sounds like the exact same problem, will check the throttle cable tomorrow. It was so bad in traffic today, that my truck kept trying to surge ahead in stop and go traffic and my breaks heated up almost to the point of failure. :censor:

pulled over let the truck cool down, then drove well, until it heated up again...
 
I had this problem last week. I found that it was the throttle cable adjusted a wee bit too tight.

Robbie (Powderpig) said he's seen this before. I haven't seen any issues since I adjusted it a bit longer. I probably moved both nuts on the cable housing at the throttle body about 1 turn. It's easy to do with 2 wrenches (12mm I think).
 
Confirmed that my problem was throttle cable. Simply pulling it up with my foot alleviated the issue. New cable ordered. Was very scary, as my truck got warm in stop and go traffic, was idling up to 2800 rpms and overpowering the brakes.
 
Literally just fixed this problem by pulling my fast pedal backwards with my foot while idling. It was sitting at like 1,100-900revs in park or neutral
 
Back
Top Bottom