Help, fj80 wont move

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 31, 2002
Threads
21
Messages
145
Hi all,

my wifes 1991 fj80 decided to have a problem yesterday. She was about to pull out of a parking lot, but when she hit the gas it doesn't move but makes a clunking/grinding sound. It grinds in both drive and reverse but not in neutral. I towed it for a block to get it out of the parking lot and it still made the grinding noise with the engine off and both the tranny and tcase in neutral (while i was towing it). I checked tranny fuild and it is full, but I haven't checked the tcase or diffs yet. I am thinking that the tcase maybe lost its fuild and snapped the shaft. what do you all think?

Thanks,
Jason
 
Where is the noise coming from? Sounds like a stripped drive flange, listen to see if it's coming from one of the front hubs/tire area. Will it drive with the CDL locked?
 
Good call on the CDL. If the CDL locked = movement with noise it is a front flange. Given that it does this in neutral also supports the theory. Pop a hubcap and have a peek at the flanges in the front...should be pretty obvious if it is stripped or if it sheered the studs.

Alternative theories are higher dollar, but all involve differentials or t-case breakage. I am hoping (two fingers crossed) that it is a flange. That would be a low dollar fix, even if you have stripped studs. Just a pain to get the old studs out if they are sheered...ask me how I know ;)
 
Remove both wheel center caps, and both small round grease cups so you can see the tip of the axle. Have your wife hold the brakes and push on the gas until you hear the noise while looking closely at one side to see if that's the side. You'll see the axle shaft rotate, indicating stripped wheel flange. Helps to use a grease pencile or marker to make a horizontal line across the axle to see movement. One side or the other will slip. Call Cdan and order a new drive plate. Takes an hour to install if you're slow - don't even have to remove the wheel.

DougM
 
Tools are us was right, it moves in 4low. Thanks for the repair tip Doug. I'll let you guys know how it goes.

Thanks,
Jason
 
Back
Top Bottom