HELP - Electrical Connection Question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 14, 2014
Threads
13
Messages
212
Location
Buena Vista, CO
I tore apart the dash of my 97 FZJ80 Collectors edition to deal with a rodent nest and when putting it back together, I cannot remember what this electrical connection is for. It looks like it just hooks back up to itself and I do not recall disconnecting this. In the picture below, this is right below the ignition near the steering column. Without it connected, I can start the cruiser just fine, did not try to drive yet since the seats are all removed for further cleaning. Anyone know if this is for some other option or something?
 
Looks like your OBD II diagnostic plug, which is used to read error codes
 
Last edited:
Check out this thread for more information on the OBD II plug/connector.

OBDII reader or cable?

Or search OBDII

You can buy an OBDII code reader online for about the same cost as the dealership will charge to read one engine error code. A good investment !!
 
Last edited:
The OBDII plug is right above the fuse box on the left of the steering wheel below the mirror controls. This is the other side below the ignition.
 
This is what mine looks like.

14585119589211534099804.webp
 
Based on the EWD, pg 25-ish, I'd say that's for the steering wheel airbag squib, connector A19.
 
I was thinking it was for the security system since the wires from that plug run back towards the driver side kick panel. Also this plug basically goes in line of the ignition plugs, one into the female and one into the male end of the ignition plug. I just bought this rig and it did not come with any alarm fobs, so I left it disconnected and everything seems to be working fine. I also have a 1996 80 and I looked at the wiring on it, but it looks different, so I assumed it was due to the alarm system. My 96 has similar plugs, but the wires are completely different, and I assume it is due to an aftermarket, non Toyota, alarm system.
 
The other connectors in that area are for the ignition ring light and something else ignition related. I'd check the EWD, but I don't believe they are aftermarket.
 
That is the adaptor harness for your alarm.

Also in the area will be the ignition switch wires going through another harness plug.. this is plugged in-line and allows the alarm to interpret what is being done with the switch and interrupt the ignition if needed.

I assume your alarm doesn't work.. Also, if your alarm is removed from under the seat the truck will not start unless the plugs in the picture are removed from the ignition switch circuit, as pictured.

Basically if you don't want your alarm you can pull the kick panel and remove these plugs, as well as the other stuff that taps into the turn signal and door lock wiring.
 
@MDarius pic shows what it'd look like if still being used.


and just as a point of info.. if anyone's alarm acts up and they need to get the truck started to get home.. this is the part that needs to be removed from the ignition switch circuit to do so.
 
Thanks for the help guys! In the near future, I am just going to remove all of the alarm parts and pieces. Then it will give me a spot to install my CDL switch above the HVAC controls.
 
Back
Top Bottom