Help diagnosing front end squeak

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

I hate the squeaking and don't tolerate a rubbish ride very well, so I probably replace stuff earlier than most.

If the question is 'how quickly do I need to replace this before it is dangerous', then you can go quite a bit longer. Particularly if you are stressing things by offroading the truck, I am not sure why you would push things longer then you need to. Do it when you have the time/funds and don't stress.

555s are cheap enough, and the DIY takes a while but isn't hard or bank breaking.
I'll order the 555s and tackle it when I have a free weekend. I am not looking forward to the DIY. haha.
 
I'll order the 555s and tackle it when I have a free weekend. I am not looking forward to the DIY. haha.
Do a little research on the DIY before you order parts, if you have not already.

For better or worse, this is one of those 'while you are in there' projects for wheel bearings, drive flanges, snap rings, brake rotors, tie rod ends, sway bar bushings, front brakes, etc.

This is one of many good threads on the topic:
 
Do a little research on the DIY before you order parts, if you have not already.

For better or worse, this is one of those 'while you are in there' projects for wheel bearings, drive flanges, snap rings, brake rotors, tie rod ends, sway bar bushings, front brakes, etc.

This is one of many good threads on the topic:
Got it! After further inspection. I can 100% say it is coming from the inner tie rod driver side. I'm going to replace that piece only since the DIY seems straight forward. And start saving up for the front drivetrain "refresh". haha.
 
  • Like
Reactions: MJK
Closing this one out in case anyone stumbles upon it searching. Replacing the joints fixed my squeak. Using the stethoscope really helped pinpoint where it was in the front end. If you do try to have a dealership replace the uppers be prepared for sticker shock since it's not a job in their books. The lowers can be done on the truck easily with a c-clamp style ball joint press tool. The uppers have less room to work and the tech wanted to pull them off the truck to use a stand press to do those.

The indy shop, State Automotive, in Midvale, UT, did the whole job for $450. They were awesome to work with and I'll likely be headed back there for my second 90k service. Their initial quote was $550, that included an alignment afterwards, however their rack won't fit on my wheels, but that worked out fine since I have the lifetime Firestone deal anyway.

Truck drives great now, front end feels much tighter, new shocks are definitely a little more bouncy.
My truck has squeak once it gets warmed up. It sounds very faint but it’s been going on around 60k miles. I have newer LCAs. Done about 80 k ago Toyota parts. The sound almost appears to cycle at first I thought it was brakes but no I put it in the air but can’t really run it with no load for any length of time. Seems to be coming from the front of transfer case area but it’s been hard to pinpoint
 
Back
Top Bottom