Head compatibility

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 13, 2020
Threads
2
Messages
13
Location
Camas, WA
I’ve read through a bunch of forms and can’t seem to find the answer I’m looking for. Halfway done rebuilding a ‘71 1F engine and just found out my head has 3 decent cracks coming out of the exhaust seats.

I have an extra head off a ‘74 F.5 and was curious if I can use it on the 71. I know oiling is different But not exactly sure how, was just hoping to use the ‘71 valve train with the oil tube.

Which heads are compatible with which blocks?
 
I’ve read through a bunch of forms and can’t seem to find the answer I’m looking for. Halfway done rebuilding a ‘71 1F engine and just found out my head has 3 decent cracks coming out of the exhaust seats.

I have an extra head off a ‘74 F.5 and was curious if I can use it on the 71. I know oiling is different But not exactly sure how, was just hoping to use the ‘71 valve train with the oil tube.

Which heads are compatible with which blocks?
I know you can use the ‘74 for 2Fs and cannot use a 1F for the 2Fs or F.5s but looks like the ‘74 still has the hole for the oil tube is there any reason can’t use it for a 1F?
 
I just went through this with my 72 F motor. Best specific advice I got was to look at the compression chambers and if they were the same there shouldn't be a problem. My head was a 60032. Found several replacements. 60031 should be a 70-71. There are close up pics of that on my build thread Here. I would think if you can run the oil line through you should be good to go, but that's pure speculation on my part. Good luck.
 
Really appreciate the info and the link thank you. Yeah after tons of reading still can’t find anything definitive. I don’t think there would be a fitment issue but may be a loss in compression because of the open vs closed chambers
 
Back
Top Bottom