Having some power issues with my 80

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 5, 2015
Threads
32
Messages
87
Location
92677
So I have a 97. Runs great. Has 272k on chassis but the entire motor and everything was gone through and replaced 100k or so ago. Stock suspension for now. Recently in Washington state I took it out off roading. Ran through some deep puddles. Got in some tight situations. Made it out ok tho. But my power steering stopped working... and my car idled weird and noticed some power loss. Since then(3 days), the power steering is working fine again. But something else is holding back the already minimal power I had at certain rpm ranges (1200-2500). Its boggy, then will hot about 2600 and give me it's all. Also when it cold starts, it rev bounces around 800 and 1200 depending. Sometimes it will hold at 1400 then drop to 800 range and be struggling for a little, then back up to 1400. I dont know if it's the fuel filter/pump that's restricting it. Or if I need to maybe clean the TB. Maybe the cats? I'm just trying to get an idea of where I should start diagnosing this.
 
Don't know about the power steering problem your having, but about your idle problems. You might try unplugging your TPS (it might have water in it) and Blow it out with some compressed air. Then plug it back together, start it up and see if you got your idle back and if your power is back between 1200 to 2500 RPM.
 
Duggy is onto it. The distributors have 3 or 4 holes in the back to vent moisture, which coincidentally allows tons of moisture in during water crossings. Mine is easy to tell as it will idle around 250-300 rpm when the dist gets wet.
 
Does your Check Engine light come on briefly when you start the rig?

I don't rememer seeing it come on at all. Ill have to pay attention to that when i start it next

QUOTE="duggy, post: 11388465, member: 67648"]Check for moisture in or around your distributor[/QUOTE]

Duggy is onto it. The distributors have 3 or 4 holes in the back to vent moisture, which coincidentally allows tons of moisture in during water crossings. Mine is easy to tell as it will idle around 250-300 rpm when the dist gets wet.

I'm going to check that. Im away on vacation for the holiday but when I get back I'm going to check it out. Might just replace my spark plugs, just cause, and then I'll check for water and moisture in there. Do I need a new gasket if I take it off to check it?
 
Back
Top Bottom