harmonic balancer

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 21, 2005
Threads
4
Messages
5
I have a 1977 fj40 with the straight 6 . I want to take off the harmonic balancer
but I am worried about the large nut on the front, is this a left hand or a right hand thread, and what is the best way to get it off, by the way this is my first project of this type and I need all the help Ican get, any help would be greatly appreciated, thanks
 
It's a 46mm nut. Normal thread (righty-tighty, lefty-loosey). The best way to remove it is with a 46mm socket and a breaker bar. Lay the breaker bar on the driver side frame rail and bump the starter. If all goes well, it should break loose. If all doesn't go well, you'll end up tossing you breaker bar through the roof. :D
 
Is the motor still in your truck? If not, turn the block on its side, jam a block of wood up into the block and turn the motor until a connecting rod is pressing on the block ( I used a short 2 by 6). Then get a buddy to stand on the motor. Using a 46mm socket and a long cheater bar, have at it... Toyota lock-tited the nuts on, or so I'm told....

Don't make the mistake I did and use the flywheel locating dowel on the crank for any sort of bracing... It will damage the crank....
 
How about a good impact wrench? Gotta pull it from an 81 2F. Still need to find a 46mm socket :D
 
Back
Top Bottom