H150/151 question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 2, 2002
Threads
636
Messages
20,040
Location
Helena MT
does anyone know if the input shaft is the same for the trans versus what engine it is used for?
Is just the bellhousing changed for each engine block? 3F, 1FZ, 2UZ
or is it the bellhousing and the input shaft that need to match the engine of choice?

not sure where to ask this question.
 
The answers to these questions depends on what truck (model/engine/transmission/world market) it came from honestly. Typically, H151's come with the coarse spline (14 spline IIRC) and H150's come with fine spline (21 spline IIRC).

Try and post this in the 24V/Diesel section, that mob seems to have a lot of info about this question.
 
Back
Top Bottom