Gotta growl

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 11, 2003
Threads
104
Messages
539
Location
Mountaintop, Pa
Folks, A couple of ??'s for the team. Today I'm getting a growl / humm in the driveline that was not there before. At speed I put in in nutral for a few seconds and it does not go away. It almost sounds feels like it not in overdrive.
(but it is)

I did do the front rotors about 1K miles ago. I followed the procedures as best I could. Could this be it?? I felt the spindles after a 15 mile hiway drive. they are "pinchy" hot not scalding flesh cooking but more than warm to the touch. Also the birfs look good. I'd expect the greese to run out iff'n they got real hot. Lastly I checked the vehicle drift after it's been sitting for a while and it moves freely. Is this correct thinking????


If not I guess it could be my front d shaft joints. I was driving around the yard the other day and moving the suspension around on my normally asphault bound mall cruiser.

Any thoughts should I pull the front hubs and check things out. What am I looking for?


thanks
bob
 
I pulled the PS hub apart and check the lock nuts and all seemed OK re-torqued and did not get a chance to take it on a ride.

Also I broke on of the studs on the drive flange are these replaceable??? How much rotational play whould there be in the drive flange???

thanks

bob
 
There should be no rotational play in the drive flange. It should be seated tightly on the hub and torqued to spec.

The sheered stud can be replaced, you will need to get the old one out, easy out, drill, etc.

You can also rule out driveshafts by removing them one at a time and using the center diff lock to drive.
 
For future searches.

It was the DS wheel bearings. The lock nuts came loose. After 500 miles post rotor and brake job. I never would have thought that. I was ready to pull the front D-shaft. But checked the wheel for play. Tourqed the back to spec and she's good to go.

bob
 
Back
Top Bottom