Getting Front Flexy

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Nay

Joined
Aug 17, 2004
Threads
134
Messages
5,102
Location
Colorado
I recently installed a MAF 4+ front panhard - this is the unit with a spherical joint on the frame end. I was out on a great run today, and the pic below is showing a good amount of front end flex, which I was feeling all day in a really positive way. Seem more than usual, i.e. freeing up the front panhard helps increase front flex?

Or just the amount of twist on this line was forcing more flex in the bushings?
OCG Front Flex.webp
 
tough angle but it looks kind of normal to me. I've been kicking around the idea of designing a bracket that would allow for a bolt on "Y" link setup. But I don't know enough about them to really commit to the project. Any thoughts on that?

I ran a Y-link on my old XJ, problem is that to get them to flex you need bigger bushings, and more rubber = sloppier front end.

I think if I was going to do the work I'd do a traditional 3 link with a 20" or so lower arm if that length would work, lower mount flush with the tube.

I was trying to see if it was angle in the pic or not on the flex, but the angle of stuff into the wheel well looked way better than I usually get. It was a pretty big line on that climb, I was really surprised the front flexed enough to stay planted. I haven't been able to get anything close to that by flexing on my typical makeshift RTI ramp in the form of construction gravel piles :D

DSC05211.jpg


DSC05221.jpg
 
Awesome crawling!! Where is that?
 
That's a cool obstacle you summitted, Nay! I've used the MAF sphericals on upper and lower control arms and they do add some flex to the game, for sure.
 
I recently installed a MAF 4+ front panhard - this is the unit with a spherical joint on the frame end. I was out on a great run today, and the pic below is showing a good amount of front end flex, which I was feeling all day in a really positive way. Seem more than usual, i.e. freeing up the front panhard helps increase front flex?

Or just the amount of twist on this line was forcing more flex in the bushings?

More front end flex a positive thing? I thought you were of the opinion it was great that the front flexed so little ;)

In all seriousness though, it may be a matter of the front axle being centered better since you went to an adjustable panhard. Just a thought.
 
Back
Top Bottom