Gas tank feed line fitting

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 15, 2019
Threads
15
Messages
105
Location
SoCal
Is this a metric flared/AN type fitting?
Anyone know what size? Will an auto parts store have something generic?
 
Does that piece have a tube that goes down to the bottom of the tank?

Also, what the best way to clean the inside, to make sure theres no particles that would clog the line or filter?

Sorry, I didn't read your question right. The items I mentioned are for connecting the fuel hard lines to the carb and fuel pump.

As for your original question, I don't think they make just the fitting/nipple to the fuel tank. Maybe you could make your own? The hard lines for the fuel system I believe are a 5/16 tubing. The flare at the fuel tank nipple/connection would be a bead type flare.
 
Is this a metric flared/AN type fitting?
Anyone know what size? Will an auto parts store have something generic?

What year of vehicle? And I just did one so now I'm a know it all. And no, those nuts that screw on to the fuel tank, fuel pump are no longer available. And no, parts store will not have anything close.
 
What year of vehicle? And I just did one so now I'm a know it all. And no, those nuts that screw on to the fuel tank, fuel pump are no longer available. And no, parts store will not have anything close.
Its 1969 FJ55.
What do you recommend doing?
 
DSCN9840.webp
 
I think one of ur questions was how to clean the tank. You’ll need to drain the tank, pull the tank, put a fistful of nuts and bolts in the tank. Well, there’s a number of other steps and you tube will do a better job than me on explaining it. Good luck!
 
how about a pic, can't remember on 55's I thought they were all barbs out the tank but could be wrong.
 
Back
Top Bottom