FZJ80L Stalling

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 16, 2006
Threads
2
Messages
5
I am down in Cabo San Lucas visiting my father. His wifes fzj80l(turbo) Will start and run fine. As soon as you hit the road and start bumping around it dies. The roads here are murder...tons of washboards. The cruiser will start right back up and go for a while only to die again. If you keep the rpms in the 2000s it will stutter but keep going. Please help me if you can. I own a 71 fj40 so this is greek to me and I am in the middle of nowhere with no manual..Plenty of tools though....:crybaby:
 
PCV valve? Fuel Filter?

Any of you guys think this might be the fuel relay?

Lets help him fix the truck so he can go have some guava tequilla at Sammy Haggars bar.
 
I cannot get it to stall while idling..By shaking anything from the coil wire to the har4ness in various places..A tech down here put it on the daignosis machine and the (mass flow air sensor?) sensor on the intake hose, was suposed to be bad so we repklaced it and that wasnt it..
 
maybe a vaccum leak? If the diagnostic showed the mass flow the huge rubber hose from the air cleaner to the throttle body tends to break.
 
Check the air inlet hose as Romer suggested. Can you describe the sputtering a bit better? Does it spit and pop like an air/fuel mixture problem or does it seem like more of an electrical problem, just intermittent firing? I know that isn't the clearest question in the world but this sounds like something is grounding out where it shouldn't be..
 
Wire harness on the PS?

Runs fine at idle but not when bouncing/shaking correct? I'd look at that wire harness for chaffed or melted wires but maybe you were indicating that you've checked that above?
 
It seems to be more of an electrically oriented problem
 
I'm having the exact same problem, but it only happens when I shift into reverse, or when i slow down from over 30 +mph. Im sick of driving with two feet to keep the rpm's up. Also, when I reverse, it sputters and the rpm's hop all over the place.
 
After pulling the intake hose i noticed some oil in the and in the turbo...about a tablespoon..so I connected what appeared to be a loose ground and put the intake hose back on and took it out. Immediately the same problem. For giggles I hit the pwr button next to the shefter to see what would happen and I could barely keep it running even after i hit the button again and the lite went out...What the heck is the power button and I think it is connected to the problem??????
 
The power button simply changes the shift points on the transmission to hold gears longer before shifting up, theoretically keeping the 80 is the "power band" longer.

Unless of course you have the Jeff Corwin edition and in that case it adds like 50hp or so :) (inside MUD joke)

I doubt seriously this could be a cause for your problems but who knows. It may point to the problem though that a poor running 80 and the PWR button would have in common and that would be electrical issues with the ECU maybe?
 
Back
Top Bottom