FZJ80 spark plug wires?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 1, 2006
Threads
28
Messages
191
Location
Utah County
I have a 94 FZJ80 with 250,000 miles on it. I bought it a year and a half ago from the inlaws for cheap. Lately the engine misses every 10-20 seconds or so. The other day, I was zapped by (I think) the coil wire while the engine was running. I could also hear a small zap noise everytime the engine misses. I take it I need a new set of spark plug wires.

My question is, is it worth it to buy from Dan or buy generics from Checker or Autozone? I want this to run as good as it used to before the missing.

Thanks in advance for your help.
 
Buy the CDan ones. Change your plugs, cap and rotor while your at it.
 
Buy the CDan ones. Change your plugs, cap and rotor while your at it.

I agree with Kirk:
Plugs: $1.66 each
Cap: $10.65
Rotor: $6.15
Cord Set: $84.64

Just received mine yesterday from Cdan.

Regards
 
Invest in original equipment - I would bet those wires on there are original equipment - if you look close the wires have a production date on them - probably 1992! No generic will last or perform this well or this long for sure! I agree w/ above - do the whole ignition system. Theyre most likely all the same age - eliminate the weak links in the system. I just did mine recently when my engine was lightly bucking while cruising on the freeway. Changed the cap, rotor, wires, plugs - good as new!
 
Definitely OEM on the plug wires, they will last you another 10-12 years and 120k+ miles.
 
I recommend OEM.
Before I knew about ih8mud I bought plugs, a cap, and a rotor from a chain parts store for our FJ80. I recently replaced them with the correct parts from CDan, and found that the original, which had always had a questionable interface between the coil wire and cap center electrode, had melted/crumbled away at the center post. The Toyota replacement parts from CDan are a much more reassuring fit, and the cap and wires are numbered, so there is not a chance of mis-wiring.
 
The OEM wires are a really nice package and last a long time, there has been a lot of poor feedback on after market wires here,
 
Thanks guys. I have a PM for Dan for the works. How difficult is the cap and rotor swap?
 
one banana job
 
I have a used set from 2004 you can take if you come get them, they are in Sandy. I am anal, and replaced mine along with plugs/wires/dist./rotor. Makes a noticeable difference.
 
2004 the same as 94? I-6 v v8?
 
2004 the same as 94? I-6 v v8?

Nope they are different, just get the correct set, the lengths are all perfect and everything lines up just like it should.
 
I think he means the plug wires were bought in '04 for an 80, not that they are off an '04 100 series cruiser.
You got it, they are labeled as mfg. in 2004. They are off my 1997 80.Shoot me a PM if you want, and I can leave them out for you to get them...
 
Very clean engine. That makes mine look very dirty.
 
Thank you guys especially Moody. I changed out everything and found that my wires were made in 97 and they were bad. #6 was frayed and the clip was broken and stuck on the spark plug. That was tricky to get off but done.

This LC runs SOO smooth. I almost forgot how they run when they are set up right.

Thanks again.
 
Back
Top Bottom