Front shock mount question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 21, 2004
Threads
73
Messages
597
Location
The Rockies or the Andes
I want to build my own mounts out of 1" DOM but I am going with FJ-60/62 PS gear box which will sit outside the frame with a 3/4" spacer right in front of the stock shock mount location. I know I can just put in Ford shock mounts, but it would much more fun to build my own, and basically free as I have leftover DOM here. Anyone out there with 60/62 PS who has tried or done this? Or am I dreamin and should just go buy Ford shock mounts?

Could I change the angle of the shock mount (and therefore the shock) and push the top mounting point farther out from the frame to clear the PS gearbox? I seem to remember reading that you actually want to keep the top of the shock close in for articulation? Any guidance would be greatly appreciated. :cheers:
 
Ok how about this. Is it possible to fab a shock mount out of a single column of 1.5" or 2" DOM? Put it in the same location as the stock shock mount, bent a little to the outside of the vehicle for shock clearance? Add some gussets maybe?

I want a shock tower that will add lots of travel versus the stock one but that I can make myself. I'm not cheap, I just love making my own sh_t.
 
Yep, you can.

So you are doing 60 PS as well?

I went F-250 mounts in preperation for mine.

Do you get the TT? In Mark Whatley's write-up he used tubing and square tubing for mounts.

Remember geometry, the more upright the shock, it is more firm. Our rear shocks at a 30 degree angle will feel softer...
 
PabloCruise said:
Do you get the TT? In Mark Whatley's write-up he used tubing and square tubing for mounts.

Remember geometry, the more upright the shock, it is more firm. Our rear shocks at a 30 degree angle will feel softer...

I dont have that issue of TT, Chris Hatfield mentioned that article too. Thansk for the pointer on geomtry though, thats exactly the kind of info I was hoping for.
 
IanB said:
I dont have that issue of TT, Chris Hatfield mentioned that article too. Thansk for the pointer on geomtry though, thats exactly the kind of info I was hoping for.

I think Brian's threads are much better at explaining this than me...
 
Anything is possible...Ford mounts are just so easy and have a clean, factory look. They are also dirt cheap brand new from the dealership.

I would only fab mounts if I were running a tube fender kit and wanted aditional strength and a tie-in to a underhood radiator protection cage...but bending and welding is fun

good luck
 
Back
Top Bottom