- Thread starter
- #21
Sorry for the delay, I have been working all week and not had any time to do the job, but yesterday I did have a day off and did the rotor change.
I decided to do a part refurb of the calipers, pump each piston out far enough to clean up the piston and a nice smear of Molycote high temp rubber grease and the put back on the rubber dust cover, all went well unto the last piston, I accidently pushed it out to far and popped it out, but only very slightly, I managed to get it back in and as I pushed it back I opened the bleed nipple so not to push any air back up the pipe, grrrrrrrrrrrrr
I thought it was going to be a nightmare after that, but only had to bleed that one side and brakes are solid, I will bleed the rest of the system today but they do feel ok.
I took the car out when I finished at 8pm for a short drive and they felt good, no pulsing and braked fine but I only used them lightly as I want to bed them in properly today, I would have done it last night but I couldnt remember exactly how it should be done.
One of the main things I did notice on the right hand side, was the new disc rubbed on the caliper, I will start a new thread on that one, cos I think it needs to be discused as a completely different problem.
I will bed them in today and reply later on.
I decided to do a part refurb of the calipers, pump each piston out far enough to clean up the piston and a nice smear of Molycote high temp rubber grease and the put back on the rubber dust cover, all went well unto the last piston, I accidently pushed it out to far and popped it out, but only very slightly, I managed to get it back in and as I pushed it back I opened the bleed nipple so not to push any air back up the pipe, grrrrrrrrrrrrr
I thought it was going to be a nightmare after that, but only had to bleed that one side and brakes are solid, I will bleed the rest of the system today but they do feel ok.
I took the car out when I finished at 8pm for a short drive and they felt good, no pulsing and braked fine but I only used them lightly as I want to bed them in properly today, I would have done it last night but I couldnt remember exactly how it should be done.
One of the main things I did notice on the right hand side, was the new disc rubbed on the caliper, I will start a new thread on that one, cos I think it needs to be discused as a completely different problem.
I will bed them in today and reply later on.
no more I hope