Front pinion seal help!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 2, 2006
Threads
30
Messages
305
Location
Calgary AB.
Website
photobucket.com
I'm trying to replace my front pinion seal and it looks different when I pull it part than the part I got from the dealer. By searching I found that the part number I have should be the proper one but when I undo the pinion nut and remove the flange I see a flat, goldish surface. I figure this should be the pinion seal but it has a different part number and looks different than the one from the dealer. Any idea what I'm looking at or a tip on how to proceed? The part number on the seal that's leaking is AD2261G but the seal from the dealer(38047) says AH2261J. Any help? I'd like to get this thing on the road this weekend. Thanks. ....Steve
 
OK, now I've got the nut off for the transfer case front output seal and I'm seeing the same thing. I guess that means I have the right part number but I have a new problem. How do I get the old seals out? The flat side is tight and flush so I can't pry them out. I haven't tried really hard though since I'm not sure I'm doing it right and don't want to make it worse. Any help out there tonight? Thanks. ....Steve
 
you should be able to get the tip of a screwdriver between the seal and the pinion gear gear shaft and just gently pry out on it. if that doesnt work try gently driving the screwdriver through the metal on the seal, the metal is fairly thin and it should split easily and then pry it up and out. and use a rubber mallet or put a piece of wood over the edge and gently tap the new seal in while working your way around the seal so it seats evenly. you may have to tap the seal around the edge with the hammer to get it to start going in before you use the mallet or piece of wood. i hope this makes sence and helps, good luck!
 
lone gunman said:
. i hope this makes sence and helps, good luck!

Thanks for the reply. I figured that was what I had to do but I was scared of damaging something I shouldn't. I'm cleaned up now so I'll give it a shot in the morning. I figure about 10 more of these little projects and I should be nearly leak free. :rolleyes: Thanks again. ....Steve
 
PabloCruise said:
Hang in there - it takes a while to eliminate the leaks...

So far I've had the tranny and transfercase all apart and managed to fix a few of the leaks from there. Now all I need is the rear main maybe, the front output, front pinion, replace the steering stabilizer and a new felt washer in the speedo cable. Hopefully then I can park in the driveway without creating an oil slick. ...Steve
 
Enigma said:
well let us know how it goes. I noticed a drop on the driveway the other day, looks like my front pinion seal is starting to leak as well.

I'll let you know. I picked up a truck at the auction and spent today getting it running so the cruiser sat. Maybe after dinner tonight I'll have another go at the seals. .....Steve
 
Back
Top Bottom