Front Hub Socket Size??

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 9, 2008
Threads
52
Messages
203
Location
Northern CA
I am replacing the left front rotor on my baby - 94 Land Cruiser by following previous write-ups in the FAQs section.

What's the hub socket size to remove the hub locknut? The writeup in the FAQs section says 54mm but I can't find one anywhere and I have tried all local auto stores like Autozone, Kragen, Harbor's Freight and Sears. Plus, the picture posted in FAQs section does not look like a 54mm.

Thanks
 
I am replacing the left front rotor on my baby - 94 Land Cruiser by following previous write-ups in the FAQs section.

What's the hub socket size to remove the hub locknut? The writeup in the FAQs section says 54mm but I can't find one anywhere and I have tried all local auto stores like Autozone, Kragen, Harbor's Freight and Sears. Plus, the picture posted in FAQs section does not look like a 54mm.

Thanks


Search 54mm and this is what it yields: Read post 11.

https://forum.ih8mud.com/60-series-wagons/290019-real-time-help-1st-knuckle-rebuild.html
 
I used a 2 1/8" socket from Sears, this is the closest SAE equivalent and works great. Just used it a couple days ago for my second front axle job. It comes in a 3/4" drive, so you will have to buy an adapter for a 1/2" drive. You can probably find a 2 1/8" socket at some autoparts stores as well.
 
Just make sure it is a thin-wall socket. Tried a standard 3/4 drive proto 2 1/8" and it wouldn't fit inside the hub. Just call CruiserDan down in Albuquerque and get a real one ordered. Most of the sockets you will find are in the $50 and up range. There are other places you can look too. Just look at some of the supporting vendors.

Just my two cents...
 
Just make sure it is a thin-wall socket. Tried a standard 3/4 drive proto 2 1/8" and it wouldn't fit inside the hub. Just call CruiserDan down in Albuquerque and get a real one ordered. Most of the sockets you will find are in the $50 and up range. There are other places you can look too. Just look at some of the supporting vendors.

Just my two cents...

The standard Craftsman 2 1/8" socket fits fine inside the hub, don't know about other brands. There are plenty of guys who have used the Sears Craftsman socket.
 
I am replacing the left front rotor on my baby - 94 Land Cruiser by following previous write-ups in the FAQs

54mm ...

And why would you replace only one of your rotors?
 
54mm ...

And why would you replace only one of your rotors?

2x

If one is toast and the other's pristine, then you're likely replacing a caliper too.

Otherwise, if one is worn, the other should be just as bad.

Then you get into the whole, 'while you're in there', which will quickly lead you to re-packing birfields and maybe swapping sides with them and replacing bearings and races and sending Cruiserdan a pile of money via Visa and...

I understand being frugal and all, but if you have a bad rotor, best to check the other side or figure out why one side failed earlier than the other.

IMHO YMMV
 
After rebuilding my calipers for the first time (with the front axle service) last week, I would definitely rebuild the calipers or replace them, every time I do the pads from now on. OEM seal kit is cheap.
 
Back
Top Bottom