Front e-locker shaft seal

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 15, 2005
Threads
142
Messages
1,138
Location
San Diego, CA
Website
battlebalm.com
Hey guys,
I just got through my e-locker rebuild on the front axle and everything looked good. On the shaft of the factory locker actuator there's an o-ring (to seal the locker and diff) as well as a second rubber seal to seal the locker actuator internals from anything getting into the actuator.

I didn't see anything pointed out about this second rubber seal in the couple of locker rebuild threads here, so I thought I may post about it to see if anyone has replaced theirs and if Toyota has a part #.

Thanks!
 
Since I heard nothing but crickets chirping on this thread, I did some homework. I was able to special order a bunch of these seals and now have extras.

I assume that either no one has bothered to replace these seals in their factory lockers or they missed it during the rebuild process.

If you're doing a factory locker actuator rebuild and you want to replace all the seals, you'll need this seal too.

$2 and I'll mail you a pair.

Sorry, my camera sucks at taking closeup pictures...

IMG_5883mod.webp


seal.webp
 
Sorry to be reviving this old thread, but I'm basically in the same process of completely rebuilding my front e-locker.
Does anybody know the size of this mysterious x-ring/quad ring?
Unfortunately I'm based in Germany, which doesn't really make it easier to source one.

Cheers,
Mark

Edit (off-topic):
Damn, just noticed I was a silent reader of this forum for six years.
Thanks to everyone for everything I've learned here. I hope to contribute soon.
So far I've written down everything I've replaced during my HDJ80 rebuild and will post parts lists for rebuilds and pictures once I'm closer to joy about the old girl again :)
 
dbmaxpayne: could you post up the source, brand, part numbers of the seals you've discovered that fit??
 
dbmaxpayne: could you post up the source, brand, part numbers of the seals you've discovered that fit??
Sure, mate.
Ultimately I was planning on doing a whole thread about my rebuilt, but as the Cruiser is like a time-sucking black hole, I probably won't get around that for another while.

However, as I'm based in Germany my sources probably won't do you guys any good.

Parts list for front e-locker repair
1x O-Ring for the Motor Cover (73x2mm - Source: IR-Dichtungstechnik)
1x O-Ring for the Main Cover (53x2mm - Source: IR-Dichtungstechnik)
1x X-/Quad-Ring for the Output Shaft (9,19x2,62 mm - Source: IR-Dichtungstechnik)
1x 608 ZZ Bearing for the Worm Gear (Source: Pretty much any bearing shop)
1x Synco Lube (German/European Name) / Super Lube (American Name) Synthetic Dielectric Grease (Source: Amazon)
(Time will tell if I will regret not having used the expensive Toyota/Molykote grease... However, this stuff was as close as I could find without losing an arm and a leg)
1x Assortment of Old Ballpoint Pens
(in case you lose the little springs behind the motor's brushes like I did :D)

As my motor cover's o-ring groove was so badly worn, I have added silicone sealer to that surface in addition to a new o-ring).
 
Back
Top Bottom