Front diff oil drain- slight foam / bubble

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 7, 2017
Threads
84
Messages
444
Location
Indiana
Just drained front diff on my 80. There was some black gunk on the plug and very fine bubbling and silver dust in the fluid. Nothing seemingly alarming. Any reason for concern based on the pic of the fluid I drained? Note: the fluid was warm, fresh off a 10 mile drive, when drained.
1714383C-E749-4C6B-9813-121F2116C086.webp
 
I think your head gasket is about to blow.......
 
The "silver dust" is probably just moly from the birf grease, suspended now in the diff oil.
Perfectly normal and no harm.
There is a normal slow migration through the shaft seal, from birf to diff.
Mine was totally iridescent grey, after way too long between diff oil changes.

Black gunk on the plug is fine magnetic gear wear particles.
Also normal, within reason.
Experts here might offer info on how much is a problem. I don't know.
Mine had a thick snot glob of it.

Not sure about the bubbles, but maybe normal because you just drove it.
Someone here posted a video by Gale Banks showing the vigorous pumping / slinging action that goes on by the ring gear spinning through the fluid.
 
Last edited:
Bubbling is OK. Nothing special there. Just drain and pour in new. Nothing there is scary. If it looked like chocolate milkshake or didn't run out, then there would be a problem, but nothing I see there is a deal breaker or requiring flushing.

The "metallic" you see is more so from the moly and a little gear wear, but nothing serious.
 
@Indiana80, I think it would still be good idea for you to pull the steering knuckle fill plug, to check if you've got a case of biff soup going on. If the grease inside the steering knuckle is all soupy, you'll need to plan on a knuckle seal replacement/rebuild.
 
Thanks for all the replies. The knuckle was rebuilt about 2
1000 miles ago. The pic doesn’t show it (because the drain container also had some used motor oil in it), but the diff fluid was still a golden color and it drained very smoothly. The reason I drained it to begin with was (start of new thread), when I get up to about 60 mph I get a low bass drum noise only when applying load. It is most noticeable between 60 and 70mph, then kind of goes away. My wife, sitting in the passenger seat doesn’t really notice it or feel it. To me it sounds like a light drumming noise (very rapid) and I can feel it in floorboard. Let off accelerator and it goes away. I don’t think it’s diff related b/c the gear oil looked good, aside from light bubbling and a little sludge on magnet. I’m going after u-joints next. It does make a clunk when shifting from park into reverse or drive. I’ve read that’s also a symptom of a failing u-joint. Just not sure if a ujoint would only really start to vibrate at 60mph. Any thoughts?
 
Meant to type “the knuckle was rebuilt 1000 miles ago. Don’t have my readers on.
 
The clunk from park to reverse can also be control arm bushings as the drivetrain puts load on the axles.
 
The clunk from park to reverse can also be control arm bushings as the drivetrain puts load on the axles.
Thanks for reply. Control arm bushings are fairly new OME caster correction bushings. They look good, and are tight. My stabilizer bushings are in bad shape, but I don’t think they would be the culprit.
 
Thanks for reply. Control arm bushings are fairly new OME caster correction bushings. They look good, and are tight. My stabilizer bushings are in bad shape, but I don’t think they would be the culprit.
What about your rear upper and lower control arm bushings?
 
U-joints create harmonics based on speed. I'll bet on a bad u-joint with those symptoms. There will be another speed that you'll feel it hear the vibration, but that's because it hits a point you can actually feel it or hear it.

Also confirm that the front drive shaft is 90 degrees out of phase and the rear drive shaft is in phase.
 
U-joints create harmonics based on speed. I'll bet on a bad u-joint with those symptoms. There will be another speed that you'll feel it hear the vibration, but that's because it hits a point you can actually feel it or hear it.

Also confirm that the front drive shaft is 90 degrees out of phase and the rear drive shaft is in phase.
Thank you for input. Front shaft is 90 degrees out of phase. Rear shaft is in phase. I’m thinking front u-joint b/c there is vibration when harmonics are just right- between 61 and 65mph, then things start to smooth back out. There is a faint vibe from about 40mph to 61mph. There is also a distinctive “tink” when shifting from park to reverse, reverse to drive and drive back to reverse. One other distinct thing I just noticed, the tink when shifting gears only occurs when the vehicle is warmed up after a drive. Doesn’t seem to tink when shifting when vehicle is cold after sitting overnight. Not sure if u-joint noise will occur only when warmed up?
 
Back
Top Bottom