Front diff lock question.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Well lads I finally got the front arb installed and I tells ya I'm impressed.
This thing rocks, makes the 80 near on unstoppable now.:)
 
Did you say "part time 4wd" ? I didn't know this is an option. I have often wondered if my LX450 would use a lot less gas in 2 wd than 4wd. You know if anyone has done any work to make a full time 4wd into a selectable 2wd for those city miles ?

Do a search in the FAQs. There is a kit ($$$) you can buy but those who have done it have not seen much/any MPG improvement.

I've run without a front shaft for extended periods, and haven't seen an improvement in mileage.
 
Do a search in the FAQs. There is a kit ($$$) you can buy but those who have done it have not seen much/any MPG improvement.

I've run without a front shaft for extended periods, and haven't seen an improvement in mileage.
dont look at it as a fuel saver, but as a drivetrain saver.
 
Do a search in the FAQs. There is a kit ($$$) you can buy but those who have done it have not seen much/any MPG improvement.

I've run without a front shaft for extended periods, and haven't seen an improvement in mileage.

There is a thread on this right now, the reason you're not gaining fuel economy is b/c the front hubs and transfer case is still spinning...
 
Question: will Aisin hubs off a 4Runner work on a 91 LC? Sorry for the newbie question, just picked up a LC this week... Have owned 85 and 94 4Runners and have crossed over. Thanks!
 
garsh...a lot of deep pockets here....


IMO, a Detroit TrueTrac would be a viable option as well.
 
Not IFS; off solid axle...
 
Thanks. Anyone have any experience/input on the Slee Part Time kit?
 
I'd like to lessen the wear and tear on the front axle and hopefully gain some mpg.

Curious as to why you say mileage won't increase - less drag, less mass to turn.

And you don't loose anything, just becomes manual...
 
I have read on several posts that the 80 gets similar mpg with or without the front end turning.
I am just reiterating what I read about on mud. Good luck with your project.


You DO lose AWD on road. the rig supposedly handles differently in 2wd verses AWD mode.
 
You DO lose AWD on road. the rig supposedly handles differently in 2wd verses AWD mode.

Any vehicle will act differently in these two variable operational environments.

That said, wear and tear on the front end would be my top reason for doing a 2wd conversion....as opposed to saving a 1-2mpg ratio.

-o-
 
I realize it will handle differently; just looking for input on the kit. Wanting to know how it changed wear and tear, seal life, handling and mpg... It'd be nice to get 15 mpg! LOL
 
My mileage increased after installing part time...

Apparent power increased as well - truck felt "zippier" around town.

Even if the mileage increased only 1mpg, it has already paid for itself in my case.

Also, we all know that with taller lifts, front driveshaft vibration becomes a problem. The best way to correct this is a cut n turn, which requires welding and a reasonable amount of time. A lot of people turn to a CV front shaft, which is just as expensive as a part time kit without any of the other benefits.

Bailey
 
Even if the mileage increased only 1mpg, it has already paid for itself in my case.

How do you figure? At current prices, a 1 mpg increase is like saving 1-2 cents per gallon.

($2.30 / 10 = 23 cents per gallon VS $2.30/11 = 21 cents per gallon)

I suppose if you count the reduced maintenance costs of the front end that number goes up....but.....still....
 
Back
Top Bottom