front brakes seized up

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 26, 2005
Threads
247
Messages
3,274
Location
City that rhymes with fun
i was finally out enjoyin my cruiser when i noticed the front brakes were stickin really bad so i pulled over and they were smokin! i let it sit for 20mins then tried to drive again to limp it home and they were jammed solid no budgin. i let it sit an aditional 30 mins and they must have cooled enough to unlock. i was able to limp it home. i havent time to dive into it tonight but what do you guys think could have caused this? they are stock drums up front. could it just be shoes too old. no grinding or anything before hand. thanks
 
Says drums...

Dude, you just need to do a full teardown/inspection and I would advise that you replace them with discs ASAP. I fought endlessly for years with drums and they just aren't worth it.

Look for leaks, frozen pistons in the wheel cyliders, broken springs, and sticky friction areas on the sides of the shoes.

The front wheel cyls are double sided pistons and if they get corroded inside they can wedge themselves inside and jam up and stick.

Good luck.
 
Bretty, in one of your previous posts you mentioned working on a '67. Assuming that is which vehicle we are discussing here, it's usually the case when BOTH front brakes are locking up on a single reservoir system that the brake pedal is just adjusted too tight.

Try loosening the pedal pushrod on the back of the pedal where it connects to the master cylinder and turning it in a turn or two just to see if it makes a difference. Don't be suprised if all of a sudden your pedal now goes all the way to the floor when you try to stop!:eek:

Good luck

Mark A.
 
yes it is a 67 and i know i should swap to disks, how hard is it too go from drums to actual toyota discs if the whole axl is available disks and all. ill try adjusting first before i get too carried away. is it common for the front drums to adjust themselves to the point of full all like i expirienced today? thanks for the tips guys
 
Not to insult anyone, but are they properly adjusted in the drums? I know the drums need a lot of attention, but good braking is feasable with proper adjustment.

just a thought.

Rezarf <><
 
no offense takin ill have to see if the yare adjusted properly. it just seems wierd to suddenly do this, ive done no brake work to the cruiser yet. and it was fine for a week already since i started driving it again.
 
As far as replacing your front axle with a disc LC front, you might just want to swap both axles from the donor vehicle in order to keep the same gear ratio front to back. Not sure bout the axle strength front to back, might also be an improvement.

For properly adjusted brakes, they'll work good for a while. If you plan to keep them for the time being, I'd buy all new wheel cylinders so that they're less likely to bind up. And stay outta the mud or water, that's usually the culprit for the problems.

JMO
 
thankyou for the advise im gonna get them apart ltr this aft then i can actually see what the deal is in there.
 
SOunds like you are on the right track. I would give everything a good cleaning while you are inspecting.

It is funny that it happened all of a sudden, perhaps they were just barely rubbing and once they got hot enough they locked up.

Good luck, you will get it!

Rezarf <><
 
Back
Top Bottom