Front Axle Completed

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 14, 2007
Threads
2
Messages
50
Location
Rigby, Idaho
Well, with no wrenching experience, but given the confidence to take on the job after reading all of the threads/FAQ, I completed the front axle service. Keep in mind, this is from a guy that sits at a desk most of the week, and previously has had "pro's" do all of the PM on my vehicles, boats, motorcycles, etc.

I've owned the LC for about a month now, and have baselined all of the fluids, changed out all the hoses, belts (what a difference....very quiet now), radiator fluid (toyota red). Still have the rear axle service to complete, and change out the U-joints.

Suggestion to other noob's: Get a parts washer! Wish I had one, and will purchase one before my next job. From looking at the internet, does not look like they are that expensive, but I believe the time I spent doing the axle could have been cut in half with a parts washer, and much less mess.

Another suggestion: Make sure you examine/replace the trunion bearings. I'll post a photo of one of the bearing sets I took out, but one of the rollers was completely destroyed. There were no symptoms of there being a problem, so I was a little surprised when I observed the damage.


Anyway, enjoying a few "step six" beverages :beer: :beer: , and have a feeling of accomplishment that I don't get from shuffling paper.

Thanks to everyone who contributes all of their ideas/suggestions.

Aloha, Joe
 
Way to go, my man. Wait till you do it again on the trail. It will take 1/5 the time and you will seem to others a god among men. That said, it's a messy messy job, isn't it??:cheers:
 
Congrats Joe. Glad you were able to get it done. I had a similar feeling after I did my first front axle because I hadn't really worked on a car since college (20 years) It becomes additive. Just watch the plastic nipple on top of the radiator when you do engine work.
 
Back
Top Bottom