Frankenbumper!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 13, 2006
Threads
36
Messages
464
Well I was trying to go for this:

dunas15.jpg



after a couple more beers with the fabricator, I ended up with this:


067.jpg

068.jpg


I posted a shot in a different thread not intending to show it off and one of the other 80 dudes called my rig "The Train"!! I guess it is a LITTLE big ... :hillbilly:
 
I like Zombie Plow too! .. now I just need some OME heavies in the front to pick the front end up a bit. I could have had my buddy cut "Prius Pounder" into the front plate too .. I need a winch at some point so that's out.
 
It's cool but I need something with a little more reinforced heft (side bars), and more sharply angled to deflect deer strikes. My last deer strike pushed the left front part of the bar back against the front quarter panel. I have small horizontal bars covering the gap between the center and far left vertical bars which prevented the deer's body from taking out the headlight and front turn signal. Big bars with big gaps don't make sense to me. Doesn't keep smaller stuff from getting though and doing serious damage.
 
I can see what you mean .. I don't think a deer is going to cause any damage to the front quarter panels. That tubing is as heavy duty as one can go. The part about the gap .. I am going to address that, just not quite sure how yet. Thanks for the input!
 
Bumper looks great, the bull bars remind me of how they armor up semis in Aus and NZ. All Aboard!
 
Hire Mel Gibson for a driver.
 
Remember, their heads are soft. BRAAAAAIIINNNNS!!!!!
 
You know what Dan .. I finished watching the Road Warrior about a month ago for the 100th time and know I think that may have had something to do with this build as well. :D
There is always something running around at night on the roads around here .. :zilla:



Now I feel safer ..

:grinpimp:
 
Back
Top Bottom