Fj80 help wanted

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 20, 2016
Threads
55
Messages
449
Location
California
Couple of days ago I put bigger tires on my fj80 after which i noticed a little leak coming from the wheels at first I though The big tires caused the leak from brake fluid, but then I realized its gear oil from differential coming through the knuckle house. Since I don't hear any weird noises from differential gears or axles do you guys think that it's only the knuckle seals that have gone bad or there is something more?
 
As you can see the leaks on the picture and that's driving it slightly, if I get on the highway and drive the leak becomes worst.

image.webp
 
Probably just the seal. Mine did that. Drove for awhile like that just keeping it topped off until I ordered parts.
 
I'm a very novice level mechanic and it was very doable for me by myself with the help of the jonseys YouTube guide and the FSM.

My two bits: have all the parts and tools you need ready to go and give yourself plenty of time to do it right.

It's very straightforward, just messy, smelly, and takes a bit of time. I did the driver side on Saturday and the passenger side on Sunday. Having done it just once, I think I could do it again in half a day start to finish.
 
Adjust the wheel bearings. Larger tires apply more lateral stresses.
 
Replace axle seals with oem only.
 
Can you elaborate on that? I'm not sure how to adjust.
Perhaps you should buy a factory service manual (FSM). It will be rather expensive but an indespesibke tool in your quest to maintain your Landcruiser.
 
Can you elaborate on that? I'm not sure how to adjust.

Whose kit did you go with? If from us (Cruiser Outfitters) it came with full instructions that include wheel bearing preload instructions. Otherwise consult the FSM
 
Back
Top Bottom