FJ40 Tub Alignment Process

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

It isn't even for the look. The guy who sold me the truck had 2 aftermarket fenders in boxes. I bolted them on after I put the tub on. One of them looks fine and is level, however the other is tilted about 7 degrees to the side even when I try and level it as much as the tub allows me to. I am wondering if the fender was just bent on shipping or if the truck tub isn't put on properly.

I wish I had more time to spend on it. I work in NYC and only get to go out and work on my truck one or two weekends a month, so I tend to do some crawling online before heading out. Otherwise I'm sure I could figure it out in good time.
 
It isn't even for the look. The guy who sold me the truck had 2 aftermarket fenders in boxes. I bolted them on after I put the tub on. One of them looks fine and is level, however the other is tilted about 7 degrees to the side even when I try and level it as much as the tub allows me to. I am wondering if the fender was just bent on shipping or if the truck tub isn't put on properly.

I wish I had more time to spend on it. I work in NYC and only get to go out and work on my truck one or two weekends a month, so I tend to do some crawling online before heading out. Otherwise I'm sure I could figure it out in good time.

Makes sense. You’re not alone in struggling to find time to work on your 40.

The quality of aftermarket fenders can be quite variable. It does sound like the one is tweaked. Hopefully you can shim or bend it to make it fit well enough.
 
Back
Top Bottom