FJ40 floor question? (1 Viewer)

[ludwig]

Ok I'm replacing the floor pan on a 1975 FJ40, as seen in my post.".It all started with pulling the harmonic balancer". My old floor was nothing but a bunch of plates on top of plates. So not much original was left .

Question is : Does the floor pan run the parallel to the frame, or does it have a slight rise to the rear which is what mine does with what was left of the original floor pan? Mine was one bubble back on the level.

Take in mind that my tub is sitting on the frame with NO body mounts, just metal to metal.

Thanks

 

[ludwig]

So since no one has chimed in on level or not, I guess it is not that big of a deal.

I will carry on as planned.

 

[brian]

There are three different elevations.
The front floor to around the back of the front seat.
The mid bed which is approx 3-4 higher.
And the bed, which is only an 1 or 2 above the mid bed.
All are level to the ground.

 

[ludwig]

There are three different elevations.
The front floor to around the back of the front seat.
The mid bed which is approx 3-4 higher.
And the bed, which is only an 1 or 2 above the mid bed.
All are level to the ground.

Understood, I'm just concerned with the driver's/ pass. floor below the rear floor. Thanks brian back to the trenches!