Finaly!!! My First Mod!!!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 18, 2006
Threads
121
Messages
1,206
Location
LOS ANGELES
Website
www.destechservices.com
Hey guy's and gal's... I finally installed my first mod..... Air Bags!!! I need them to help ballance the load when pulling my new travel trailer. Now after this would come the dual battery set up but for now........ pics... We are still installing as I post. ... will add final pics soon.
DSC_0273.webp
DSC_0274.webp
DSC_0272.webp
 
Last edited:
Where are you placing the compressor and tank for this set up? Engine bay?
 
Where are you placing the compressor and tank for this set up? Engine bay?

They look like the same ones a friend installed on his 100. If they are, you run lines to somewhere like your bumper and terminate them with a air chuck. So, you deflate or inflate them manually. He's got his split and terminated on his bumper (one on each side). You fill them with a compressor (or CO2 tank) according to your load and just use a tire gauge to equalize them. For a softer ride or no load, you just let air out. They're amazingly inexpensive, I think the ones for his 100 were like $80.
 
good job!


(you may want to consider sturdier stands to keep it up in the air :) )
 
How about installing a "T" for the air lines so that you have a single fill point and no worries about equalization. I realize that you couldn't use the bags to compensate for a lop-sided load. But that never happens anyway, right?
 
How long do those air bags last ?


Kalawang

I've had mine in for 3-4 years now and they are still working fine.

NorthBay80 - lots of discussion about single vs dual fillers. Most of us are using dual so air doesn't transfer from side to side with either lopsided loads or cornering loads.
 
K guys... I will be using no compressor... caus its the econo way to go. 79? dollars shipped at www.autoanything.com ...:D got this info from a fellow muddr's post.... Any how the kit came with a "t" if you wanted to go that route. I desided to line them seperatly. both lines run on driver side of the frame (to avoid the exhaust).. and placed the end on the lower DS end of the bumper.... (bearly visable). I will post pics... soon.

I went this route because I did not like the thought of most of the air transpering to one side while cornering.... (onramps/offramps in the concrete jungle are long and tight.) Oh and I placed both of the ends together that way I can adjust/inflate without running round my 80. Oh and I like the handling... I has improved....sure I can't beat an F-40 on cornering but I noticed a drop in rear cabin roll...

the instruction say that I must keep it between 5 and 35 psi....? got to confirm.. I will get some pic's.... tonight. Sooooo....


So far I like it and think that it should go in the "most bang for ya buck" section....

Oh and if you see... aside from the bottle jack... I gots the little "mule" further back for "just in case" Oh and we placed the wheel under the frame as well....

:cheers:
 
Looks like a worthwhile mod for 80 bucks...congrats!
 
Back
Top Bottom