- Thread starter
- #21
Got the new knock sensors put in. I ripped the wire off of the front sensor trying to get the connector off. Then, I barely touched the thing and it all started to crumble (inside trying to remove pin). I finally get the pin out and solder the wire to it. probably not the best, but I went with a bullet connector and then sticky heat shrink wrap. I prefer crimp/solder/seal connectors, but I didn't have any for 16-18 ga wire. I'll maybe upgrade that at some point.
Did a diagnostic lap and no CEL. So far, so good.
O'reilly's knock sensors do appear to be made in Japan. Pics below. Thanks for the help everyone.
Did a diagnostic lap and no CEL. So far, so good.
O'reilly's knock sensors do appear to be made in Japan. Pics below. Thanks for the help everyone.
