f & 2f heads

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 22, 2005
Threads
3
Messages
18
Location
millen, GA
I,m thinkinking about rebuilding my 2f and putting it in my 72FJ40 but Iwas wondering what the difference between the heads of early and late f and 2fs are. does anyone now what combustion chamber sizes a re for all of the castings? also port volume and flow of heads? I cant seem to find any flowbench sheets on any of them.:confused:
Ive got a 72 F and a 80 2F. will be using homemade pistons probably(have acess to cnc mill)
 
The '72 oils the rocker assembly differently. The head you want from an F is the late '74 "F-and-a-half" oils like a 2 F but smaller combustion chamber so it raises compression.

Ed
 
Flow rates? Runner volumes? You're barking up the wrong tree. This is a tractor motor. Yah I know you're gonna say there are such things as souped-up tractor motors in tractor pulls, but it ain't the same thing. The only way you're gonna get more air thru an LC motor on the scale you're looking for is to turbo it.

If that interests you, do a thread search. Mace has done one [and he LOVES to talk about it!];)
 
maybe turbo, but i wanted to know what head flows the best. My brothers got a sbc in his 78fj40 and hes constantly breaking stuff. I like the old straight six and
just want to beef it up considerably:D
 
Andrewfarmer on this board purports to get 6500rpm from his 2F and has posted a detailed thread on the buildul of the motor. There is even a video link on here somewhere. Just do what he did. I think he gets close to 200hp on propane.


https://forum.ih8mud.com/showthread.php?t=61396

ED
 
Last edited:
Well if your gonna make new pistons, drilling the oil port for the rockers should be a piece of piss, then use the 2F rockers and install larger studs for the 2F manifold. Just use the 2F head as a blue print. I think the F head has higher stock compression, but as far as I know the porting is the same.

The 2F head may need flat top pistons which would limit your compresion, again Andrew Farmer or Mark Whatley would be best to talk to.
 
If you're that concerned about flow, you'll need to get the 'early' inlet manifold, but be aware the 'ears' are thinner than the later ones so you may have issues with your headers...

Also, if you flow it too much you'll get more high end hp out of it, but loose the low end torque.
 
Back
Top Bottom