Engine Noise

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 2, 2004
Threads
87
Messages
3,533
Location
San Francisco Bay Area
I am just starting to understand my engine. I am about at the point in deciding if it is time for a rebuild on my 2f. When I take off or rev the engine I hear some weird noise. It seems to get louder when there is a load like taking off instead of sitting reving it in neutral. It is coming from inside the engine. It sounds like some loose metal rattling. I thought it was the valves but I checked the valves and adjusting them and noise has not changed.

What else can I check? :doh:
 
You can drop the pan and check the cam, bearings and pistons (partially). If it hasen't siezed, you have time to fix it.
 
Could be pre ignition, also called ping, also called detonation. This noise sounds like you threw a bunch of marbles into the engine. Happens more under load, like accellerating up a hill. Many causes (the fuel ignites too early as the piston comes up, causing the rings to rattle; stressful and very bad for the motor). Check your timing, should be 7 BTDC. Use the highest octane fuel (higher octane fuel resists exploding), make sure your plugs are the proper heat range or even try a cooler plug. Unplug your vacuum advance from distributor (if you have one); too advanced total timing can cause pre ignition. Carbon fouling from oil getting into the combustion chamber is a BAD cause of pre ignition and indicates a need for a rebuild. Check your compression.
 
Hard to speculate with what you describe, could be something other than your engine. Clutch? Tranny? DOes it happen when you are sitting static in nuetral, or does it happen when you are in gear and drive? Does it happen only under load?
Could be a rod knock, worn piston pin, etc, etc.
 
Back
Top Bottom