Engine harness removal on '94

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 18, 2006
Threads
73
Messages
904
Location
Michigan/Costa Rica
I've pulled the engine and disconnected the harness from the engine. I'm trying to remove the harness from the cab. I've disconnected the ECU connectors and a couple of other connectors in the vicinity of the ECU. There appears to be another bundle of wires that are part of the harness that seem to be routed back behind the heater-A/C box. Does anyone have a clue as how to disconnect these. This is a '94 which appears to be different than the newer 80's.
 
If the ECU is out and the other two or three white connectors that are jammed into that area are disconnected, the harness is ready to be pulled out through the hole in the firewall. It does not route anywhere else.
 
Here you go

Screenshot_20200603-080044_Drive.webp
 
Thanks guys. Got it. The third connector was hidden behind the evaporator unit so I had to pull the evaporator to access it. Evidently, the po had work done on the evaporator and had routed the cable behind it. I didn't want to pull the evaporator but now I can clean all of the crud that had accumulated in it. So in summary, there are four connector that connect to the ECM and three that connect to other harness connectors.
 
4HE1 going in?

Don't I wish! What started out as a straight forward head gasket replacement turned into an engine rebuild. I pulled the head in the truck and discovered that #1 piston wasn't coming up as high as the other so I pulled the engine. #1 connecting rod was slightly bent probably from hydrolock. I already had the head rebuilt so too much was invested to do a U-turn and go with a 4HE1.
 
Back
Top Bottom