engine cut out

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 9, 2004
Threads
121
Messages
590
Location
Kent England
I had a wierd thing happen the other day.
We was all packed up and ready to go on a camping trip, car started fine as usual, but after about a 1/4 of a mile the enging died, it did restart but very reluctant too.

I managed to drive another 1/4 mile to a safe place to stop, the engine would go ok, but as soon as you gave it a bit more throttle, it would splutter, it did clear itself once fully warmed up, so carried on and drove the 400 mile to the camp site with no problems at all.

The next day it did the same, but less severe spluttering, after the third day it was back running fine with no problems at all.

I am really unsure what it could have been, perhaps it was the really damp day we was having, I just don't know.

Has anyone else had this sort of problem before?
 
Nope.... No smoke at all, I did suspect the head gasket, but no white smoke and no coolant loss and no gurgling, and drove 400 miles straight after the problem happened, with know other problems till the next morning, when it happened again, but not as severe, only had spluttering when the throttle was used.

Milage is 135k 1996 and could not see any signs of any cracked or hissing hoses
 
Has anyone else had this sort of problem before?

I have but not in an 80 but another vehicle ('99 Dodge Durango). I'd be driving along and the truck would just die. Sometimes it would restart and sometimes it would not.

It turned out to be the PCM (powertrain control module), basically the computer was dying. The only good thing to come out of this is the dealership that normally told me they could not duplicate the problem when I would bring the Durango in had no problem duplicating this problem as they swapped the computer with a "rebuilt" one only to have the PCM die on the tech who had it out for a test drive and was a couple miles away when it died. He had to walk back to the dealership :D

From what I've read on MUD the more common problem that causes similar issues to what you are describing is the wire harness running near the exhaust manifold and going through the firewall. In this harness wires can get melted from the heat or chaffed going through the firewall and cause sporadic issues.

HTH
 
Nope.... No smoke at all, I did suspect the head gasket, but no white smoke and no coolant loss and no gurgling, and drove 400 miles straight after the problem happened, with know other problems till the next morning, when it happened again, but not as severe, only had spluttering when the throttle was used.

Milage is 135k 1996 and could not see any signs of any cracked or hissing hoses

I guess that means you don't get any CEL either? I can think of trying two things on top of my head:

1. Disconnect the negative battery cable and reconnect it. Start up the truck and try doing the same things, see if that fixes the problem.

and/or

2. Disconnect the MAF sensor connector clean it up and re-connect it.

I am not sure but sounds like some thing simple like a malfunctioning wire/connector.

Good luck:cheers:
 
I guess that means you don't get any CEL either? I can think of trying two things on top of my head:

1. Disconnect the negative battery cable and reconnect it. Start up the truck and try doing the same things, see if that fixes the problem.

and/or

2. Disconnect the MAF sensor connector clean it up and re-connect it.

I am not sure but sounds like some thing simple like a malfunctioning wire/connector.

Good luck:cheers:

You'll have to do that if it occurs again though....

if it is running fine, you may not ever know what fixed it, or if it was a fluke.....
 
It happened again this morning when I first started the car up, it has been very rainy and damp, which is exactly the same as the last time it cut out.

On both occasions, it had been raining all night and very damp, it starts fine, so no problem there, after about a 1/4 of a mile, and at the very same spot as last time, just about to go up a slight hill, it just dies, on both occasions it did restart but very reluctantly and splutery

When it starts and you engage the gearbox, it drives off fairly ok, but as soon as you try giving it the slightest bit of throttle, it splutters and jerks badly, lift the throttle and it will crawl along, I drove the car about another 1/2 a mile with very light throttle, as it would splutter if you tried to add to much gas.

I stopped at the local garage and purchased a can of WD40 and strayed the distributer cap and the leads, it restarted ok and it did run better and after another mile it was running fine.

perhaps it's the ignition leads need replacing, I will see what happens in the morning, as its raining all night here again and very damp, if it starts ok and runs, I will assume its the leads as I have sprayed them with WD40

I will let you know what happens. if anyone else has had this problem, let me know :-)
 
I had a similar occurance after replacing the valve cover gasket. (luckily in the company of a master tech)
it turned out to be a dirty air sensor. carefully disassemble your air intake tube - the air sensor is inside a bullet shaped plastic piece. spray it out w/ contact cleaner, check there are no obstructions inside the tube and reassemble.
that did it perfect for me, never an issue again. don't know why but no problem before or after that- could be the movement caused some debris to shift inside the tube...
good luck!
 
I recommend replacing your sparkplug wires, especially if they are original, they need to be replaced anyway, by now. Lots of similar problems happen with marginal wires.
 
I had a wierd thing happen the other day.
We was all packed up and ready to go on a camping trip, car started fine as usual, but after about a 1/4 of a mile the enging died, it did restart but very reluctant too.

I managed to drive another 1/4 mile to a safe place to stop, the engine would go ok, but as soon as you gave it a bit more throttle, it would splutter, it did clear itself once fully warmed up, so carried on and drove the 400 mile to the camp site with no problems at all.

The next day it did the same, but less severe spluttering, after the third day it was back running fine with no problems at all.

I am really unsure what it could have been, perhaps it was the really damp day we was having, I just don't know.

Has anyone else had this sort of problem before?

Check the easy/simple things; contaminated gas, vacuum lines,
ignition wires, air intake, etc.

Had my 80 tuned up at the dealer; noticed it ran worse the next day,
not better; I looked at everything; finally looked at the rubber air intake; the mechanic, while in a hurry(they all are) apparantly yanked hard on the rubber air intake causing it to rip apart about
75% of the way around the circumference; of course, he just put
it back together; so, looking at it, you could not tell anything was wrong as the torn area was in a fold and mostly at the back and bottom. I glued and taped it up for a temp fix, and my car ran fine until I got a replacement.

Check the simple things; and add a couple of bottles of water remover to the gas tank just in case you got a big slug of bad gas.

G
 
Back
Top Bottom