Electrical woes need help

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 3, 2015
Threads
6
Messages
22
Location
jacksonville nc
So a couple weeks ago we went out wheeling and the truck just died, it would crank over just not fire (95 fzj80) I posted in here looking for a harness because I found 1 burnt wire in the harness and it looked burnt next to the egr . Well today I finally had time to dig a little deeper and pulled off all the tape and old heat wrap to try and find/fix the problem but to my surprise all the wires look in good shape except the one that burnt up it's a single black wire with a red stripe on it. I couldn't find any melted together or cracked/brittle. I'm very mechanically sound and know my way around motors but when it comes to electrical I am a little nieve, I can fix simple problems but w.o pulling the harness completely out I was hoping somebody might have some insight on where I should start looking or what might cause this. sorry for the crappy pic
Thanks

20180218_104158.webp


20180218_104145.webp
 
The cause is a direct short to ground (EGR pipe) of that black w/red stripe wire. Insulate it, replace whatever fuses/ fusible links blew, and you should be good to go.
 
There are 6 black/red wires that EACH feed +12V to EACH injector. That +12V source is fused via the EFI fuse. Very common when the clip that keeps the harness away from the EGR valve breaks with age and allows the harness to rub against the EGR till the rubbing wears through the OEM wrap and the insulation and then you have a short which typically will take out the EFI fuse at which point you are stranded. The other failure mode is that it rubs and shorts the ground switched side (the ECU momentarily grounds each injector to allow fuel to be injected) of one of the 6 injector ground side wires and you get stumbling/misfires as the engine rocks on the engine mounts.

As the post above, repair the damaged insulation if that is all that's the problem or cut and replace the section of wire if the strands look damaged (crimps, not with solder).

Re-wrap that section of the harness with decent heat proof wrap and implement a quality solution to the broken clip to keep the harness off the EGR valve.

cheers,
george.
 
Thank you for the replys! I traced to wire and cut out the bad section and ran a temporary jumper wire just to test it out and she fired right up! Now I just gotta crimp and heat wrap the wires and re wrap everything! I was hoping it would something simple and no involve pulling the harness or worse swapping harnesses
I do find it odd though because no fuses or links were blown in process of it shorting out
Another question would it be acceptable to wrap the harness in header heat wrap where it is close to the egr or is there a better alternative I can find on the shelf in a auto parts store

Thanks again !!!!
 
Nice find dude! I wrapped my harness with header wrap so you should be good to go.
 
There SHOULD be a stand-off bracket below the EGR that you are supposed to tie the whole harness back to. It looks like it should be holding spark plug wires.

The reason 1 lousy wire was able to kill all 6 injectors is simple if you look in the EWD. One wire comes thru in the main harness to supply 12+ to all 6 injectors. It branches out right above #5. Each injector has a dedicated ground wire that runs thru the harness to the ECU. The grounds provide the trigger signal for each individual injector. Struggled with this on mine and others rigs to resolve misfire/no fire problems. Tools R Us is the wiz that got it all figured out for us.
 
Make sure you use ethier shrink tubing or the shrink crimp connectors(I prefer the shrink tubing). Don't need to be going back in there down the road cus the connection is all corroded
 
Back
Top Bottom