electrical flux

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 16, 2006
Threads
1
Messages
6
New and excited to be here. My 77 gauges stopped working for a while. They came back on but with a ticking sound and fluctuating volt meter. These both speed up with more electrical things i turn on. Any insight would be great. Thanks
:confused:
 
ZACK77 said:
New and excited to be here. My 77 gauges stopped working for a while. They came back on but with a ticking sound and fluctuating volt meter. These both speed up with more electrical things i turn on. Any insight would be great. Thanks
:confused:


What Voltmeter?? :flipoff2: :flipoff2:

You left a turn signal on?
 
take it off and look at your connections to your guages. There is 2 wires on mine that are hot. the ones that screw into the lugs. Your explaination needs a little more. It kind of sounds like it's not a guage problem.
 
the gauge thats shows elec current (i'm assuming) when you turn the key. It would show nothing if the battery was dead. It moves back and forth-faster with more stuff in use. I will probably have to catch up on some of the lingo as I get more involved.
 
the gauge needle acts spastic. yeah, could be volt regutator. ticking sound comes from that area. i had some trouble starting it and the connection there was fairly corroded. Thanks for the help
 
ZACK77 said:
where should i get one? why not ccot?

I don't think they are that expensive so try cruiserdan for a OEM.

I ordered one from CCOT and installed it and my voltage was like 15 volts. There is no warranty on ccot electical items. I called them anyway and they told me the one I had was good(I call BS). My old one wasn't bad just rusted up so I threw it in and keep the new one out.

IMHO CCOT is not terrible, just avoid certian things.
 
WES1977 said:
I don't think they are that expensive so try cruiserdan for a OEM.

I ordered one from CCOT and installed it and my voltage was like 15 volts. There is no warranty on ccot electical items. I called them anyway and they told me the one I had was good(I call BS). My old one wasn't bad just rusted up so I threw it in and keep the new one out.

IMHO CCOT is not terrible, just avoid certian things.
IIRC 15V in a 12V system with no load isn't that unusual.


Zack77, your symptoms are exactly the same as I saw before my Voltage regulator went totally south.
 
It turns out that there is no voltage regulator being used. The alternator connects to a relay and then to the elctronic ignition. I assumed too much before looking closer at what I had. I replaced the relay and everthing is back to the way it was in the begining. The relays seem to be used as a temporary solution. Should I rewire it corectly using the voltage regulator which I have bought.
 
wire/s from alternator run to two relays. one relay connects to dist cap(elec ignition) the other runs, i'm guesing to everthing else. alternator is not internally regulated.
 
Back
Top Bottom