Electric Mark 8 install pics

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 27, 2004
Threads
9
Messages
80
Location
Sacramento CA
Almost finished with the new radiator and Mark 8 fan install
Still waiting on the DC controller
Started it up tonight and just wired the fan directly to the battery, boy does this thing suck some air
Looks like its going to do a good job of keeping the engine cool along with the new aluminum radiator, was able to sqeeze an 25 1/2 x18 1/2 Northern,.
Will be trying it out next Saturday on Barret heep trail
Trying to get out while its still hot to give it a true test
Took a few pic with the camera phone so sorry about the quality
 
Last edited:
Horns are right off a Union Pacific Locomotive
Took a lot of shoe horning to get all three under the hood
I like the look on Peoples faces when I blow it as I'm crossing train tracks, almost caused a couple accedents when people slam on the brakes and start looking for the train while crossing
 
pontiota said:
Horns are right off a Union Pacific Locomotive
Took a lot of shoe horning to get all three under the hood
I like the look on Peoples faces when I blow it as I'm crossing train tracks, almost caused a couple accedents when people slam on the brakes and start looking for the train while crossing


Are they air operated or electric? If pneumatic, must have a huge tank there somewhere!

Ed
 
Went for a short drive today with the fan hard wired to the battery to test.
Went well temp barely went about 180 went getting on it but its was only in the 80's this afternoon so Saturday will be the real test on the trail and in the 90's.

I'm looking to drop in the 455 Pontiac this fall with AC after the wheelin season, so I need a little extra cooling (gobbs of torque).

I guess I'll have the wire the fan up to a knife blade switch for temp fix if my controller doesn't come in (just got a reply and they are a couple weeks behind).
Have any of you guy tried a fan controller, www.dccontrol.com, its a little expensive but it fixs the start up spike by starting the fan up slowly and speeding it up as the temperature increases by controlling the voltage. The guys on several HotRod sights seem to really like these and after you factor in the cost of a couple of High Output relays and all the wiring the cost doesn't seem so bad.

About the Horns their are three, the largest one is on the drivers side and is probably close to 20 in long and has a 9 in bell.
Wasn't easy to get then under the hood I had to make a couple manifolds and split them up.
I run with a 2 gallon air tank under the rear and the front bumper so a total of about 3 gallons of air at 120lbs and I run a regulator between the ARBs
 
Back
Top Bottom