For Sale Durango, CO - Rockbox Offroad Aluminum Series Trailer (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Location
Durango, Colorado United States
Rockbox Aluminum Series Trailer

Asking $8250/OBO

-Clean CO title in hand

-We've taken it though the Sierras, Death Valley, The Mojave Road and Moab and it's been a great little basecamp.

Details:

-Locking lid, battery box and rear door
-22 gal, baffled stainless steel water tank with 2 faucets.
-Lock and Roll 360 degree articulating hitch system with short and long drawbars and 2 adjustable vehicle-side hitches.
-17" Stealth Custom Series wheels
-Nitto Ridge Grapplers 295/70/17 (33.5")
-Leaf sprung 3500lb Dexter axle
-10" electric brakes
-7 pin connector
-2" receiver on rear of trailer frame
-Steel subframe reinforcements have been added
-Stainless marine-grade piano hinge added to box lid to replace welded bullet hinges

Electrical:
-100 Amp Hour AGM battery
-Renogy 100w solar panel
-Renogy Voyager 20 solar charge controller
-15 AC charger with external charge port
-Blue Sea switch to control solar inputs.
-Blue sea dual USB ports w/voltmeter
-Adventure Trailer external solar charge port


Accessories:
-Snomaster LP66 fridge w/cover
-Oz Tent Foxwing 270 awning with custom telescoping mount and Drifta cover (fits much better than the original OZ Tent cover)
-Front Runner load bars
-Front Runner slider
-Powertank 10lb propane tank bracket
-Rock lights (RGB phone ap powered)
-Front and rear scissor jack stabilizers
-250lb lid struts installed. 300lb struts included
-NO TENT INCLUDED

Issues:

-We had a weld fail in the aluminum framework of the tongue (not up to supporting the weight of a fully loaded trailer) on our first outing which necessitated some structural repairs.
Rockbox took the trailer back and added a steel subframe. In addition we had a local fabricator run 2" square steel tubing the length of the trailer to make it bombproof. It is ready to roll now.

-There are a couple of small cracks in non-structural welds on the aluminum box. I haven't had time to find an aluminum welder so haven't gotten around to addressing these.

Asking $8250 OBO

IMG_1328.JPG


IMG_6258.jpg


IMG_1335.JPG


IMG_1340.JPG


IMG_6256.JPG
 
Great guy to deal with. GLWS Nat.
 

Users who are viewing this thread

Back
Top Bottom