Driving me over the edge without lights ;^)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 10, 2014
Threads
4
Messages
7
Location
West Jefferson, NC
My 1978 FJ40 has been blowing the 15amp fuse for marker, parking lights & instrument illumination lights. I've tried to trace the culprit and fell upon this fix (he says with fingers crossed): I took out the instrument cluster, disconnected the main electrical connector to it, etc. and took it completely out of the vehicle. I put a new fuse in and it worked without blowing. While out, I tighten all screws, cleaned up the light connectors, etc on the cluster. Then I reconnected the main electrical connector, etc and reinstalled the cluster. It appears to be working...now here's my questions... could there have been something about the cluster that might have caused a short? Also, is there a recommendation of someone who will go over the cluster to make sure all is good? Any help or insight would be very much appreciated.
 
Not sure about the cluster, but id check the reverse switch wiring between the switch and the harness (under the truck)... Mine intermittently rubbed against the e-brake drum and kept blowing the headlight fuse.

Also had problems with melting the fuses due to fuse panel contacts that weren't clean enough... sometimes blew, and sometime melted the solder out of them.
 
Is everything connected to that fuse working when the fuse isn't blown? If one thing is not working it could be the loose wire to whatever that is that's shorting it.

Cleaning all the contacts on the instrument panel and fuse is a good idea, but in all my experience so far with my 40 90% of the time the problem is a short somewhere.
 
There are a few lights that were in the dash when it was new. Do you still have the downward-facing dash light in the dash pad? What about the heater control illumination light? If those were cut off at some point in it's life the wires may be swinging around inside the dash. You could have disturbed them when pulling the cluster and (temporarily) solved the problem.
 
Thanks for all the good advise. I did isolate one of the 2 license plate lights as a potential culprit. I disconnected that light and all worked good yesterday. I'll look for a replacement.
 
Back
Top Bottom