Drilling springs

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 1, 2002
Threads
29
Messages
245
Location
Boise ID
I spent about ten min. drilling my second leaf on the rear to swap front to back. I remember reading on this board that a masonary bit work good.

It DIDN'T work good, it worked GREAT.

only about a min and I was done.
 
I don't know if my bit was dull or what but I spent about 10 min working on the stupid thing and only had a hole about 1/8 of an inch. Put the masonary bit in and the chip started to fly.

I like the fact that the the speed was slower and it generated less heat.
 
Hadn't heard the masonry big trick, will give that a shot one of these days...

I have one hand-sharpened bit that I've used for many years on springs....haven't sharpened it since it was done originally....the cutting edges are steep and curved, not straight like a stock bit would be. Bet I've plowed thru 20 leaves with that thing, no problems.
 
Back
Top Bottom