Door panel help.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 15, 2016
Threads
25
Messages
106
Location
Edmond, OK
So had the door panels off today and as expected, a lot of the little red "plugs" that hold the door card to the door are either broken or bent. No biggie, I can replace those. However, what are my options for attaching them to the card where the hole has either torn, delaminated, or just gotten too big to actually hold the plug? I tried to get creative with some glue, but they just pulled right back through. Options?
 
Try gluing some 40# cardstock to the cardboard backing, in 1.5" square or 3x1.5" size. Wrapping the reinforcement over the edge will make the best repair, but you'll have to use thinner cardstock; maybe like 20#. You'll have to punch a hole through them, but this will create a reinforcement, just like those three-hole punch things from Office Depot.
https://www.staples.com/Avery-Reinforcements-for-Hole-Punched-Pages-Clear-200-Pack/product_166322
I need to do this on several of my doors too.

x2 on the interior trim panel tools. I (finally) broke down and bought a set at NAPA last month. $20 well spent for a large set.
11-pc. Trim Removal Tool Kit
(If I had found this earlier I could've saved $10!)
 
Are you planning to win a car show? No? Then do what should have been done on a Landcruiser in the first place, drill and screw using a washer you like to look at, or not, because you won’t notice anyhow especially if you have grey interior.
 
Sacrilege!
 
On my old Mazda B2600i I ended up reinforcing the door panels with fiberglass. But Baldilocks' idea works too.
 
I used some thin sheet metal to reinforce those grommet holes. I glued these “patches” in and covered the sheet metal with gaffer’s tape.
 
I rebuild torn masonite board with good old fashion roving fiberglass & polystyrene resin.

I slather the crap out of it & just redrill holes. My ds fr panel was really beat in the 450.
 
Back
Top Bottom