Door Lock Issues

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 14, 2018
Threads
3
Messages
26
Location
Austin, TX
Hello All,
so as some of you may or may not know, I recently got a '97 FZJ80 and it's been having small issues here and there. Most of them we've been able to take care of, but I can't seem to find the problem with the electric door locks. Only the driver's door works. I've tried 3 different actuators in the passenger door, thinking that was that problem, but no luck. I checked all the connections and wires, and they all seem to be in good shape. However, when the lock was moved manually on the actuator when it was outside the door, it locked and unlocked the driver door.
I'm stumped on this one. Anyone have any ideas?
 
So you can lock and unlock them from the passenger side by using the key but not inside using the switch ????
 
What happens when you try to lock or unlock the vehicle using the exterior door lock? Insert the key into the door and turn it each way.

Do you have an alarm?
 
What happens when you try to lock or unlock the vehicle using the exterior door lock? Insert the key into the door and turn it each way.

Do you have an alarm?
Nothing happens when I turn the key except the driver door unlocks manually, no clicking.
I contacted previous owner and it turns out it has an aftermarket alarm. I will try to get more info from him.
 
Nothing happens when I turn the key except the driver door unlocks manually, no clicking.
I contacted previous owner and it turns out it has an aftermarket alarm. I will try to get more info from him.

Alarms usually connect to the door lock wires behind the driver's side kick panel. In the case of my 94, they used those stupid Scotcklok wire taps and they completely sliced through the wires.
 
The locks all go through the driver's door control panel, if it has an issue it can cause a problem like you are describing.
@richardlillard1 dealt with something like this, I believe he had to replace the control panel to fix it.
 
Also, check one of the harnesses running toward that door in the driver's kick panel (one of those stuffed in the hole by the door opening). The locks go through here and these harnesses can get corroded if it's ever had a windshield leak. Also, in my case I discovered the connector was not fully snapped together only after I fried two door control modules.
 
Thank you all for the insight!
I will be pulling the door card off either today or tomorrow if time allows and check out that lock relay box. I'll also check out the harnesses to see if any of those are in lacking condition.
As far as I can tell the alarm seems to be disconnected, as flipping the switch on the dash seems to have no effect on the locks or other electricals.
 
So it turns out that all I needed to do was reconnect the alarm. It must have some sort of relay or something running through it that makes the rest of the door locks work.
Unfortunately, the left rear door didn't work so we took it apart and found that the little plastic arm is cracked inside the black plastic housing. Anyone know where to get one of these arms new? Or is there some way i can fix it without it breaking again?
Thanks.
 
So it turns out that all I needed to do was reconnect the alarm. It must have some sort of relay or something running through it that makes the rest of the door locks work.
Unfortunately, the left rear door didn't work so we took it apart and found that the little plastic arm is cracked inside the black plastic housing. Anyone know where to get one of these arms new? Or is there some way i can fix it without it breaking again?
Thanks.
The alarm piggybacks on the door control relay. If the alarm loop is open, the control circuit may have been interrupted.

The relay should function properly with or without the alarm. If it doesn't you have a problem you should consider fixing.
 
The alarm piggybacks on the door control relay. If the alarm loop is open, the control circuit may have been interrupted.

The relay should function properly with or without the alarm. If it doesn't you have a problem you should consider fixing.
Not sure how i would go about doing that, but will talk to some people and try to figure it out.
 
Back
Top Bottom