Dome light switch won't work

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 26, 2011
Threads
75
Messages
462
My rear passenger door dome light isn't working. I went to the local pick-a-part and grabbed two others and swapped them in with no success. Of course I could just be the unluckiest person in the world and have 3 faulty switches, but I think that is unlikely. Is there another common spot for these to have problems at? Thanks everyone
 
My rear passenger door dome light isn't working. I went to the local pick-a-part and grabbed two others and swapped them in with no success. Of course I could just be the unluckiest person in the world and have 3 faulty switches, but I think that is unlikely. Is there another common spot for these to have problems at? Thanks everyone
You should totally junk the truck.

Or check the door switch.
 
Did you measure to see if you actually have +12V going to the dome module???

The switch (and door pin switch) only provide the GROUND path for the bulb.

So, what voltages have you measured or you just tossing parts at it? :)

cheers,
george.
 
Measure the voltage! Even a FREE HF meter is good enough for this job.

cheers,
george.
 
I will check to see if the switch is getting power tomorrow
 
I will check to see if the switch is getting power tomorrow

Already explained above...

+12V (fused) is fed to one end of the bulb (for each dome). The switch in the dome housing (and/or the pin switches in the door) provides the GROUND path. VERIFY THERE IS +12V AT ONE END OF THE BULB in the housing. It is obvious once you remove the plastic diffuser on the dome module which end should have +12V (the end that doesn't have the switch connections). Careful if old and you've run incan bulbs since the diffuser may be brittle.

domeins.jpg


cheers,
george.
 
First things first. Does it work with the Door-Off-On switch in the "On" position?
 
^^ yes it works with the on off switch as well as with the other rear doors, just not the passenger timers door. I will get out there today with s volt meter
 
Everything at the light should be OK then.

You may have to trace the wire back from the faulty door to where it is spliced into the floor harness. IIRC, Someone here found that splice to be bad. Good luck.
 
Last edited:
Door pin switches at doors provide GROUND. So, pull the door switch out and then ground the wire to the pin switch to the screw hole there the door switch was screwed into the body. No light => you have a wiring issue somewhere back to the dome module.

cheers,
george.
 
^^ yes it works with the on off switch as well as with the other rear doors, just not the passenger timers door. I will get out there today with s volt meter
I have this issue with both my driver's and ds rear door. Doors on the passenger side engage the light but not on driver's side. I'll be checking the grounds.
 
Back
Top Bottom